ESI nEar04 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti ESI nEar04. ESI nEar04 11. Professional 4” desktop monitoring system
Anche per ESI nEar04: Manuale (12 pagine)

Stampa la pagina

ESI

nEar04

1. Introduction

Congratulations on your purchase of the ESI nEar04.

The nEar04 desktop near field monitors have been developed especially for high level home studios

and special project studios. nEar04 have been designed to overcome all the typical limitations of

conventional small sized monitoring speakers providing a special 4" polypropylene curved woofer

cone and a 1" natural silk dome tweeter. Despite the small size, nEar04 still provide reference level

sound quality and enough power for audio monitoring in a digital audio production environment.

2. Basics & Installation

For optimal performance of nEar04, read the instructions in this manual thoroughly and carefully

before you are using the speakers.

Unpacking / Handling

To remove the monitors from the carton its best to turn the package carefully upside down on the

floor or on a table and then lift the carton vertically up slowly to leave the monitors resting in the

packaging foam. Make sure that you don't grab the speaker driver units on the front to avoid

damage. Now check the monitors for signs of damage that might have occurred in shipping. In the

unlikely event of this, please contact the reseller of the product immediately. Be careful when you

remove the packaging foam. Please keep all packing materials.

Connection

High quality balanced or unbalanced audio cables are

recommended for input connection. The monitors typically

connect to the line level output of a mixing console or to a

computer audio card. One monitor has to be connected to

power connection, the other monitor is connected via the

supplied speaker wire to the first monitor. Make sure the

power of the main monitor is switched off before you connect

any audio cables. Also turn down the volume initially.

TRS balanced / unbalanced connection

Connect male side of TRS balanced or unbalanced cable to

the TRS input of nEar04 – as show on the picture above (the

picture shows the left audio channel connection only). Do

this for both the left and right audio channels with separate

cables. Make sure the power cable is connected as well.

Second speaker connection

After that, connect the second speaker with the included speaker wire. Make sure the + / - (red /

black) connectors are not swapped with each other to avoid phase problems during playback. The

complete setup will then look like shown on the following picture: