Akiyama DX-101 USB Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Giradischi Akiyama DX-101 USB. Akiyama DX-101 USB 14. Mp3 recording usb turntable

Stampa la pagina

CONTROLS AND FUNCTIONS

DX-101 USB & DX-101 USB-R

START/STOP

Press this button to start or stop the platter.

PLATTER

MOTOR OFF

Press the button to enable motor off, and the led will be flash .

Press the button again to disable function.

TARGET LIGHT

Insert target light to the deck and it will light up.

PLATTER REVOLUTION SPEEDS (rpm)

33 rpm Press 33

45 rpm Press 45

(Only DX-101 USB) 78 rpm

Press 33 and 45 buttons

simultaneously. To return to 33 or 45rpm play mode just press the

desired button.

REVERSE

This button is used to reverse the direction of the platter rotation.

HEAD SHELL LOCKING NUT

Attach the headshell by inserting into the front end of the tone arm,

then turn the locking nut clockwise with the head shell firmly held

horizontally.

PITCH SLIDER

Use this to change the speed of the platter when the PITCH

indicator is NOT lit.

TONE ARM

This is a fully manual tone arm. To start playback, gently place

the stylus on the record using the headshell finger support. Do

not drop the stylus onto the record as it may cause damage to the

diamond tip and to the record.

45 RPM ADAPTOR

Place on center spindle for playing 7" records with large center

holes.

ANTI SKATE KNOB

When a record is playing, a force is generated drawing the stylus

towards the center of the record. Set this knob to the same value as

the stylus pressure to offset this force.

COUNTERWEIGHT

Use this to balance the tone arm and to adjust the stylus pressure.

POWER SWITCH

This switch turns the power on or off, including the motor and

audio signal

POWER CORD CONNECTOR

Used to connect the included power cord.

USB CONNECTOR

USB connection (USB cable limit within 3M).

PHONO/LINE SWITCH

This is a switchable 'phono level' or 'line level' output (using RCA

jacks) which can be connected to the 'phono' or 'line' input on an

exterior unit.

OUTPUT L& R

This is the standard analog output (RCA jacks) which can be

connected either to a phono or line input on any DJ mixer,

depending on the setting of the phono / line selector.

TONE ARM ASSEMBLY

- Install cartridge here. When installing a

HEADSHELL

cartridge, refer to the installation instructions supplied by the

manufacturer of that cartridge. During installation, attach the

stylus protector to guard the stylus tip from damage.

Attach wires as follows:

White (L+)

Left channel+

Blue (L-)

Left channel -

Red (R+)

Right channel+

Green (R-)

Right channel-

S-SHAPED TONEARM

TONEARM LEVER

Controls the up and down action of the tone arm lift.

ANTI-SKATE CONTROL

tone arm so it doesn't skip outward across the record due to the

centrifugal force of the record spinning. Cartridge manufacturers

usually specify the proper setting of this.

COUNTERWEIGHT

downward pressure of the stylus to the record. Attach now by

sliding the counterweight onto the rear of the tone arm. Twist it

lightly and it will screw onto the rear shaft of the tone arm.

a. Remove the stylus protective cover, if so equipped. Never touch

the stylus tip during the adjustment.

b. Lower the tonearm lever.

c. Release the tonearm clamp and release the tonearm from the arm

rest.

d. Set the anti-skate adjustment to zero

e. Rotate the counterweight in either direction until the tonearm is

perfectly balanced horizontally (floats freely).

f. Return the tonearm to the arm rest and lock it in place.

g. Hold the counterweight stationary with one hand and rotate only

the stylus pressure ring to bring the number "0" of the ring into

alignment with the center line on the tonearm rear shaft.

h. Rotate the counterweight clockwise until the scale value

corresponding to the recommend stylus pressure

Note: The recommended stylus pressure of the optional cartridge

that may have been includ-ed with your unit is 2 grams. For all

other cartridge systems please refer to the manufactures

specification included with the cartridge.

USB SOCKET

Connect a USB Pen Drive or HDD to record your vinyl, info will

stored in MP3 format only.

PLATTER SPEEDS

Select between 33 rpm & 45 rpm using the appropiate knobs.

RECORD/STOPBUTTON

Press the button to start recording and press again to stop

recording.

This applies inward force to the

Adjustment creates the proper

DX-101 USB-R