Akiyama DX-202 Manuale di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per Giradischi Akiyama DX-202. Akiyama DX-202 11. Professional turntable

TONE ARM ASSEMBLY

1. Push the power to on and the speed indicator and the stylus

illuminator will light up.

2. Insert target light for illumination the stylus.

3. Place a record on the turntable mat. When playing a 45rpm record

with a large centre hole; place the 45rpm adapter on the centre

spindle.

4. Set the rotation speed (33/45/78) to match the record.

5. Release the arm clamp.

6. Set the cueing lever to the up position.

7. Press the Start/Stop button and the turntable platter will start to

rotate.

8. Move the tone arm over the desired groove.

17. HEADSHELL - Install cartridge here. When installing a cartridge, refer to the

installation instructions supplied by the manufacturer of that cartridge. During

installation, attach the stylus protector to guard the stylus tip from damage.

Attach wires as follows:

White (L+) Left channel+

Blue (L-)

Left channel -

Red (R+)

Right channel+

Green (R-)

Right channel-

18. S-SHAPED TONE ARM

19. TONE ARM LEVER Controls the up and down action of the tone arm lift.

20.ANTI-SKATE CONTROL This applies inward force to the tone arm so it

doesn't skip outward across the record due to the centrifugal force of the record

spinning. Cartridge manufacturers usually specify the proper setting of this.

21. COUNTERWEIGHT Adjustment creates the proper downward pressure of

the stylus to the record. Attach now by sliding the counterweight onto the rear of the

tone arm. Twist it lightly and it will screw onto the rear shaft of the tone arm.

9. Set the cueing lever to the down position, the tone arm will descend

slowly onto.

The record and play begins.

10. Set the desired pitch adjusts range by depressing the buttons until

the desired pitch is reached.

11. Adjust the pitch to a desirable speed.

12. To suspend play, lift tone arm with cueing lever.

13. When play is finished, raise the cueing lever, move the tone arm to

14. Press the Start/Stop button to stop the platter rotating.

15. Push the power to off.

dx turntables

Options are +/-10%.

the armrest and secure the tone arm with the arm clamp.