3form Fin Manuale di installazione - Pagina 9

Sfoglia online o scarica il pdf Manuale di installazione per Arredamento per interni 3form Fin. 3form Fin 9.

Stampa la pagina

Installation Manual

Instructions

Installation

Installation is basically the same for all Fins. The only

difference is the orientation and substrate that the Fin

will be mounted to.

The Fin Panels will come assembled from the factory.

The cover extrusions may be shipped loose or in-

stalled at the factory. If they are installed you will need

to remove them to fasten the fin to the wall. Remove

the top end cap and slide a screwdriver or thin rod

between the cover and base near the top. Pry outward

to snap off covers.

The Fin Panel may be removed for installation to

prevent scratching or damage if desired. Remove the

nuts and bolts fastening the Fin Panel and pull it out of

the channel.

Mounting holes are not pre-drilled at the factory in

the base extrusion. This will allow hole placement to

match structure on site such as studs or furring strips.

Drill Ø 1/4" holes on both sides of base extrusion along

drill guide lines. Holes should be spaced no more

than 30" apart and no more than 12" in from the top/

bottom.

Fasten the Fin Panel to the structure using appropriate

anchors for the substrate. Recommend 3/16" � 1-3/4"

long wood screws for wood and 3/16", 1/4", or M6

anchors for concrete or cement.

Re-install the Fin Panel if it was removed and snap the

cover extrusions in place.

Connect cable to power supply or controller.

See 3flex Series Edge Lighting Solution Document for

wiring specifications and diagram.

Cover Extrusion

Base Extrusion

Anchor

Cover Extrusion

For more information, please visit 3-form.com or call 800.726.0126

Attach to wall with appropriate

3/16", 1/4", or M6 anchors

depending on wall surface.

Drill Ø 1/4" holes

along drill guide lines

in base extrusion

Fin Panel

Section View

Remove top end cap

for access to snap

o cover extrusions

Cover

Extrusion

Fin