ClearPlus WH1-HF Manuale d'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso per Sistemi di filtrazione dell'acqua ClearPlus WH1-HF. ClearPlus WH1-HF 4. High flow series whole house 10 micron sediment filter package

Stampa la pagina

Diagram #1

STEP 5. Remove the protective plastic wrap from the filter cartridge and place it in the blue

housing sump. At the bottom of the sump, there is a raised portion in the middle (standpipe) that

will help center the filter in the housing. The standpipe will fit inside the hole that runs through

the middle of the filter cartridge. Store any spare filters in a cool dry place for future use. Check

to make sure that the O-ring is seated properly in the grove at the top of the blue housing sump,

then screw the blue housing sump containing the filter cartridge onto the black housing cap. Use

the spanner wrench to tighten.

STEP 6. Turn on the water and inspect all plumbing connections very carefully for leaks. Also

inspect the seal between the black housing cap and the blue housing sump to ensure that the O-

ring has formed a good seal. Tighten this connection again using the spanner wrench if

necessary. If this connection still leaks, turn off the water supply and check to make sure that the

filter is aligned properly in the housing and repeat your test for leaks. When you are confident

that all connections are sound, run cold water for 2 minutes at any faucet to purge air out of your

system and to prime the filter.

Important Notes:

1. The manufacturer recommends that the blue housing sump should be replaced every 10 years or if you

notice any cracks or damage.

2. This filter system should not be used with water that is microbiologically unsafe or of unknown quality

without adequate disinfection before and/or after the system.

3. Water filter systems should never be exposed to freezing temperatures - severe damage to the filter and

housings could result. Such damage is not covered under any warranty.

4. After prolonged periods of non-use (such as a vacation), it is recommended that the system be flushed

thoroughly for at least 5-10 minutes before using the water.

5. The contaminants or other substances removed or reduced by this water treatment device are not

necessarily in your water.

6. If you suspect that your water pressure will at any time exceed the maximum rating of 90 PSI (6.2 bar), a

pressure regulator must be installed before the system. It is recommended that the pressure regulator be

set at 75 PSI (5.2 bar) or less.

Maintenance and Filter Replacement Information:

To maintain the optimal performance of your whole house water filter system, filters should

always be replaced in accordance with manufacturer specifications. Filters may need to be

replaced more frequently then specified, depending on the level of contaminants, particularly