Altox TRACKER-4 Manuale operativo - Pagina 2

Sfoglia online o scarica il pdf Manuale operativo per Automobile Accessories Altox TRACKER-4. Altox TRACKER-4 4.

Stampa la pagina
General Information
Dear buyers of ALTOX equipment!
We thank you for purchasing a new ALTOX TRACKER-4 device. This device
will provide you with great options to control the location and routes of
your vehicle.
You need a SIM card for your ALTOX device. It is recommended to use
special plans for M2M equipment.
Use
Using ALTOX system you can remotely control the location of your vehicle
via SMS text messages and/or satellite monitoring system ALTOX SERVER
2.0 in the real-time mode (setting TRACKING1). If there is no GSM
connection, the device saves over 10,000 into embedded memory.
ALTOX device uses Wialon IPS v1.1 protocol which allows using other
monitoring systems that support this protocol.
Control and Programming
Algorithm for the connection of the device to the monitoring system:
-
Register in ALTOX SERVER 2.0 or any other monitoring system that
supports Wialon IPS v1.1 protocol;
- If needed change server IP address and port in the device using
instructions SERVER1 and SERVER2, respectively;
- Ask your mobile provider for APN access point and set is up using SMS-
commands APN1, APN2, APN3;
- Ask device ID using SMS-command ID1 or Id2;
- Add a new item with this ID to the monitoring system.
Control via an outgoing call
Call the phone number of the SIM card installed in the GSM module.
The phone number you are using to make a call should already be saved in
the device (see text messages SMS-commands NUM1/2/3).
Saving of the first caller's phone number into cell NUM1 follows up
automatically (cell NUM1 should be empty).
When setting CALL1 is activated, ALTOX tracker responds to the call, then
you need to enter a DTMF-command :
- Switch ON/OFF OUT1 – press 1.
- Switch ON/OFF OUT2 – press 2.
- Request status message – press 3.
- Request account balance message – press 4.
After a minute the connection is dropped automatically.
If CALL0 setting is active, the incaming call is dropped, and OUT1 reverses
its state.
SMS Status Messages:
Date: 01.01.16
- current date
Time: 00:00:00 (UTC)
- current time
GSM (0-31): 28
- GSM receive signal level (not less than 10)
GPS: 15,0
- number of satellites and HDOP parameter
Speed: 0km/h
- current speed
Volt: 12.8V
- car-system voltage
I/O: 0,0,0
- IN, OUT1 and OUT2 status
http://google.com/maps - link to the current location in Google Maps
Specifications
Parameter
Power Supply Voltage
Standby Current
Max Current for Auxiliary Output Terminals
Operating Temperature
Red
- Power Supply +12V (via fuse 1А)
Black - GND (General)
Pink
- Input IN (connection of the button)
Blue
- Output OUT2 (commutates at GND)
Grey
- Output OUT1 (commutates at GND)
Please deactivate PIN code request
before inserting a SIM Card!
LED
GSM-antenna
(adhesive tape)
GPS-antenna
(magnet)
LED status (in SIM card slot)
Solid - request to SIM card, searching/registration in the network
Slow blinking (once every 2 seconds) - waiting mode
Fast blinking (5 times every second) - establishing of GPRS/RING/SMS/USSD
Value
10V - 28V
less than 35mA
150mA
from -40 to +80°С