Dixon Bayco Istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Apparecchiature industriali Dixon Bayco. Dixon Bayco 5. Locking handle kit
Anche per Dixon Bayco: Istruzioni per la manutenzione e il funzionamento (4 pagine), Istruzioni per la manutenzione e il funzionamento (4 pagine), Istruzioni per la manutenzione e il funzionamento (10 pagine)

FloTech Thermo-Optic Sensors and Thermistor Dummy

Wiring Instructions

It is highly recommended to use FloTech FT401 jacketed 7-conductor

cable when wiring a new system. FloTech cable is designed to be oil,

UV, and abrasion resistant. We incorporate a noble tin plated

stranded copper wire which resist corrosion. These features will

provide years of reliable service.

1. After all sensors are mounted in each compartment, align the

conduit openings so they face the roll over rail. Thread in cable

glands and pull a length of cable through the conduit openings

between each sensor.

2. Cut to length leaving approximately 8 inches extra length exiting

the top of each probe holder.

3. All sensor wires must enter or leave the probe holder through one

of the ½ NPT openings. Use FloTech FT402 ½ NPT cable glands to

ensure a water tight seal. Unused conduit openings must have a ½

NPT pipe plug installed. Use pipe dope on all ½ NPT threads to

ensure a water tight seal.

4. Wire the sensor according to diagram F1 below. Double check

your wiring connection when complete. It is highly recommended to

use a small amount of Silicone RTV sealant in each crimp

connection. Fill the FloTech butt end crimps with silicone RTV

sealant prior to inserting the wires then crimp. This will provide a

watertight and vibration resistant connection.

THERMO-OPTIC SENSORS

Rev: Dec 2008