ClearSpan Premium Solar Star 104918 Manuale di istruzioni per il montaggio - Pagina 9
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Kit serra ClearSpan Premium Solar Star 104918. ClearSpan Premium Solar Star 104918 17. Home-attached greenhouse
Stampa la paginaATTENTION: The lip of the metal trim at the bottom of
the upper angled end panel will overlap the top of the
doorframe.
Loosen these screws before installing the
upper, angled end panels.
Photo shows a different greenhouse. Procedure is the
same however.
Figure 1
Diagram above may show a model of a different length.
It is used to show the panel location only. Installation is
the same for your greenhouse if it differs in design.
Visit www.ClearSpan.com for additional products and customer assistance.
The open
tube ends
are covered
with flashing
later in these
instructions.
Dashed line below shows where the trim of the upper
panel overlaps the top of the doorframe.
Retighten (Step 20)
19. Secure the end of each angled panel to the lower
panels using 3/4" Tek screws and neo-bonded
washers. See Figure 1 (previous column).
20. Retighten the screws to secure the polycarbonate to
the frame of the angled panel above the door.
DO NOT SECURE THE DOOR TO THE ASSEMBLED
FRAME AT THIS TIME.
21. After the greenhouse is assembled to this point,
return to each tube splice on the metal base frame
and install a Tek screw through the tubes at each
splice to secure the joint.
Base Frame Tubes
22. Next, secure all pass-through connectors to the
metal base tubes and square the metal base frame
by measuring diagonally from corner-to-corner.
View is from the top looking down on the frame.
3/4" Tek
Screw
8 of 16