Altrad Belle POKER Honda GX160 Manuale dell'operatore - Pagina 8
Sfoglia online o scarica il pdf Manuale dell'operatore per Generatore portatile Altrad Belle POKER Honda GX160. Altrad Belle POKER Honda GX160 8.
GB
Note:- Before carrying out any dismantling ensure that the machine is switched off.
Drive Dog Housing
-
To remove the drive dog housing, remove all four bolts (4), the drive dog housing should slide off. Remove the grub screw (6) from
the drive dog (3) and the drive dog should slide off. Re-assembly is opposite of the above.
Engine Oil
-
To replace the oil within the engine unscrew the bolt in the sump as shown (A) and allow the oil to drain out.
-
To check or re ll oil use the grey or black plastic bung (B) the oil level should be just to top of the bung hole. Re ll with 10W 30
engine oil.
Air Filter
-
To check or replace the air lter remove the wing nut on top of the black air lter cover, once this is removed, remove the second
wing nut to remothe air lter (As shown below)
1
7
5
4
Spark Plug
-
To check or replace the spark plug remove the HT lead by pulling this away and remove the spark plug.
-
To check the spark plug, re t the plug into the HT lead and hold the spark plug against the body work of the engine and pull the
engine over by the recoil. (As below) Re-assembly is opposite of the above.
Resetting the Engine Speed
Note:- When checking or resetting the engine speed, do not exceed 2800RPM.
-
To set the engine speed loosen the stop screw bracket (C) and pull back, start the engine and turn the screw (D) up or down to
increase or decrease the engine speed. Once 2800 RPM has been achieved shut the engine down. Hold the throttle level in the
maximum rev position and push the stop bracket back to this and screw back down.
2
3
6
Spark Plug
& HT lead
Servicing
A
B
Recoil
Starter
10
C
D