Altrad Belle HDC 350 Manuale dell'operatore - Pagina 10
Sfoglia online o scarica il pdf Manuale dell'operatore per Cutter Altrad Belle HDC 350. Altrad Belle HDC 350 18.
Stampa la pagina
GB
Electrical Hazard
The machine is not electrically insulated. If the machine comes into contact with electricity, serious injuries or death may result.
•
Never operate the machine near any electric wire or other source of electricity.
•
Make sure that there are no concealed wires or other sources of electricity in the working area.
Concealed Object Hazard
During operating, concealed wires and pipes constitute a danger that can result in serious injury.
•
Check the composition of the material before operating.
•
Watch out for concealed cables and pipes for example electricity, telephone, water, gas and sewage lines etc.
•
If the inserted tool seems to have hit a concealed object, switch off the machine immediately.
•
Make sure that there is no danger before continuing.
Involuntary Start
Involuntary start of the machine may cause injury.
•
Keep your hands away from the start and stop device until you are ready to start the machine.
•
Learn how the machine is switched off in the event of an emergency.
•
Stop the machine immediately in all cases of power supply interruption.
Noise Hazard
High noise levels can cause permanent and disabling hearing loss and other problems such as tinnitus (ringing, buzzing, whistling, or
humming in the ears). To reduce risks and prevent an unnecessary increase in noise levels:
•
Risk assessment of these hazards and implementation of appropriate controls is essential.
•
Operate and maintain the machine as recommended in these instructions.
•
Select, maintain and replace the insertion tool as recommended in these instructions.
•
If the machine has a silencer, check that it is in place and in good working condition.
•
Always use hearing protection.
•
Use damping material to prevent work pieces from 'ringing'.
Involuntary Start
Involuntary start of the machine may cause injury.
•
Keep your hands away from the start and stop device until you are ready to start the machine.
•
Learn how the machine is switched off in the event of an emergency.
•
Stop the machine immediately in all cases of power supply interruption.
NEVER exceed the maximum ow stated on the machine, as this might lead to failure of the cutting blade and damage to the machine.
Maintenance, Precautions
Machine Modi cation
Any machine modi cation may result in bodily injuries to yourself or others.
•
Never modify the machine. Modi ed machines are not covered by warranty or product liability.
•
Always use original parts, insertion tools and accessories approved by Altrad Belle.
•
Change damaged parts immediately.
•
Replace worn components in good time.
Insertion Tool Hazards
Accidental engagement of the start and stop device during maintenance or installation can cause serious injuries, when the power
source is connected.
•
Never inspect, clean, install, or remove the insertion tool while the power source is connected.
Hot Insertion Tool
The tip of the insertion tool can become hot and sharp when used. Touching it can lead to burns and cuts.
•
Never touch a hot or sharp insertion tool.
•
Wait until the insertion tool has cooled down before carrying out maintenance work.
Storage, Precautions
•
Keep the machine and tools in a safe place, out of the reach of children and locked up.
General Safety
10