ClearWater ELEGANCE EL20 Istruzioni per il montaggio ed elenco parti - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per il montaggio ed elenco parti per Prodotto idraulico ClearWater ELEGANCE EL20. ClearWater ELEGANCE EL20 3.

Stampa la pagina

ELEGANCE

EL20

Ster0225CP/BN/BB/BC/BZ

Ster0226CP/BN/BB

Ster0218CP/BN/BB/BC/BZ

Ster0220

Ster0219CP/BN/BB

/BC/BZ

Ster0033

Ster0117

In the unlikely event you find a part missing please contact our Customer Service Helpline on

01684 299555 for immediate despatch of part.

MAINTENANCE

IF THE FITTING BEGINS TO DRIP

1 Turn off the water supply

2 Loosen grub screw under handle, remove handle and valve

3 Carefully clean seating, rubber washer and ceramic disc

4 Replace valve and handle, then turn on the water supply

5 If problem persists contact our helpline quoting the product code

Where an aerator is fitted to the outlet of the spout, it will need occasional cleaning.

This will be evident when the water flow slows down to an unacceptable level. To accomplish

this unscrew the outlet in an anti-clockwise direction and remove the mesh. Immerse the mesh

in a suitable descaling fluid overnight, rinse throughly in clean water and re-install.

REMEMBER

Maximum water supply pressure 5 bar (75PSI)

Minimum water supply pressure 0.5 bar with the smart aerator

Minimum water supply pressure 0.3 bar with the regular aerator

Maximum hot water supply temperature 70˚C

Recommended hot water supply temperature 65˚C

If these temperatures or water pressure are exceeded, damage to the tap can result. A pressure

reducing valve may be required to be fitted in high water pressure situations.

Ster0215CP/BN/BB/BC/BZ

/BC/BZ

Ster0223CP/BN

Ster0221

Ster0214CP/BN/BB/BC/BZ

Ster0221

Ster0220

Ster0217CP/BN/BB

Ster0196

Ster0219CP/BN/BB

BC/BZ

Ster0107

/BC/BZ

It is very important that you read through the following instructions

BEFORE you install and use the tap.

We strongly recommend installing particle filters and isolation valves to both hot and cold feeds.

This will help to prevent premature failure of valves and make any future maintenance easier.

Flush the plumbing system before installing the mixer tap. This is to avoid plumbing residues

clogging the mesh of the aerated outlet, or possibly damaging the valve's washers. This is

especially important where extensive plumbing work has been carried out.

First shut off your water heating system then, with your mains stop cock closed, open the lowest

hot and cold taps in the house and allow to run until the cold storage tank and pipes are empty.

(The hot water storage cylinder always remains full).

Tools Required (Not Included)

Cross-Headed

Screwdriver

PREPARATION

INSTALLATION

Adjustable

Spanner