Edhard MKS Manuale operativo e di servizio - Pagina 3
Sfoglia online o scarica il pdf Manuale operativo e di servizio per Robot da cucina Edhard MKS. Edhard MKS 12.
Stampa la pagina
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, PERSONAL INJURY OR PRODUCT DAMAGE WHEN USING THIS EQUIPMENT, FOLLOW BASIC PRECAUTIONS
INCLUDING THE FOLLOWING:
1.
READ ALL INSTRUCTIONS BEFORE OPERATING THIS EQUIPMENT!
2.
TO PROTECT AGAINST RISK OF ELECTRICAL SHOCK, DO NOT PUT POWER BASE IN OR SPRAY WITH WATER OR OTHER LIQUID.
3.
UNPLUG POWER BASE FROM ELECTRICAL OUTLET WHEN CLEANING.
4.
KEEP HANDS AND FOREIGN OBJECTS OUT OF PUMP INLET AND OUTLET TO AVOID PERSONAL INJURY AND/OR DAMAGE TO EQUIPMENT.
5.
DO NOT OPERATE POWER BASE WITH DAMAGED POWER CORD OR PLUG, OR AFTER UNIT HAS BEEN DROPPED OR DAMAGED IN ANY MANNER.
6.
DO NOT USE AN EXTENSION CORD WITH THIS UNIT. SUCH USE MAY RESULT IN FIRE, ELECTRICAL SHOCK OR OTHER PERSONAL INJURY.
USER ASSUMES ALL RESPONSIBILITY FOR SAFETY AND ANY USE NOT
IN ACCORDANCE WITH THESE INSTRUCTIONS.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN FIRE,
ELECTRICAL SHOCK OR OTHER PERSONAL INJURY.
OPERATING INSTRUCTIONS.
1. Plug line cord into a GROUNDED electrical
outlet.
2. Insert spouts in Filler Unit (F.U.) and turn to
lock in place.
3. Switch power ON.
4. Place F.U. onto Power Base. While holding
F.U. down and against back of pump well,
press "SE" to engage drive.
5. Place product in hopper. To insure consistent
dosing, make sure product is free from lumps
and air pockets.
6. To prime pump, press "PR", then press and
hold Trip Arm un l product has begun to exit
the Spouts. Release Trip Arm.
7. To set amount to be dispensed enter a two (2)
digit number (ex. 07, 25). Amount can be
changed by keying in a new two digit number
Tel: 908.850.8444
IMPORTANT SAFETY
INSTRUCTIONS
PERSONAL INJURY / PRODUCT DAMAGE HAZARD
NOTICE:
NOTE: Amount se ng is retained in Power
Base memory when unit is switched OFF only
a er at least one cycle has run.
8. To begin dispensing, press Trip Arm.
NOTE: A slight reverse mo on is programmed
into Power Base. This helps eliminate
dripping.
INSTRUCTIONS TO CHANGE
PARAMETERS.
The following 4 steps will allow access to any
one of the 4 changeable parameters.
NOTE: Steps A‐D must be repeated to access
each separate parameter.
Step A. Switch power OFF. Press and hold "9"
and switch power ON. Display will show .
Edhard Corp.
, 279 Blau Road, Hacke stown, NJ 07840
Fax: 908.850.8445
Toll Free (in USA): 888.edhard.1
Step B. Within 1.5 seconds press "PR" ‐ display
will show . If "PR" is not pressed
within 1.5 seconds, changes to
parameters will not be allowed and
system will return to prior mode
(Normal, Automa c or Con nuous).
Step C. Press "8". If any other key is pressed,
changes to parameters will not be
allowed and the system will return to its
prior mode (Normal, Automa c,
Con nuous).
Step D. Press one of the following keys to access
desired parameter:
Key 1 = Reverse
Key 2 = Resolu on
Key 3 = Automa c Cycling
Key 5 = Reset/Test
USA
www.edhard.com