EDI DSTS-5A Manuale d'uso - Pagina 8
Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di prova EDI DSTS-5A. EDI DSTS-5A 12.
Stampa la pagina5.7 OPERATING IN THE -4A MODE
5.7.1 The-4A mode performs exactly like the DSTS-4A with the EAB-3 option. All
commands are the same. To enter the -4A mode of operation type 'x' followed by
the 'enter' key. Once in the -4A mode use the -4A commands. A list of the
commands is attached. In addition typing '?' will bring up a menu of commands.
5.7.2 Single character commands such as 'A' do not need to be followed by enter.
Multiple character commands such as 'cf' or 'd2345' must be followed by the 'enter'
key.
Command List for -4A Mode
LETTER
a
A
b
B
C
cf
cF
cm
cR
cr
dxxxx
Dxxxx
e
E
fxxxx
i
l
m
o
r
R
v
wxxxxx
Wxxxxx
x
X
?
DSTS-5A Manual
FUNCTION
Sets width Auto Track mode on. Turns off when a width is sent to the DSTS.
Sets frequency Auto Track mode on. Turns off when a frequency sent to the DSTS.
Sets normal (pulsed output) mode of operation.
Sets output signal to continuous wave (CW mode).
Checks 50 kHz clock frequency.
Sets the calibration to feet.
Sets the calibration to Fathoms.
Sets the calibration to meters.
Extend Depth range to 9999 FT/FM/MT.
Reduce Depth range to 999.9 FT/FM/MT.
Sets the bottom depth in tenths of the selected units.
Sets the fish depth in tenth's of the selected units.
Turns off the fish echo mode. Returns one bottom echo.
Turns on the fish echo mode. Returns two echoes.
Sets the reply frequency in 100 Hz units.
Returns DSTS data on input pulse parameters in this order:
Frequency, width, period, P-P voltage.
A typical string is 503,192,107,540. Leading 0's are not sent.
Sets the reply level in .3 dB steps, 0 to 255 max.
Returns DSTS modes in this order:
Calibration
Number of processed pulses received since reset
Bottom echo or fish with bottom echo
Auto width Track or manual
Auto frequency Track or manual
CW or pulsed output
Filter settled or not settled.
A typical string is 0,bot,73,awt,aft,pul,set
Returns DSTS data on output pulse parameters in this order:
Frequency, width, depth, reply level.
Resets tracking gate and adaptive filters for frequency acquisition.
Resets the DSTS to power up default mode without exiting RS-232.
Reports the software version.
Sets the bottom echo width in microseconds. .
Sets the fish echo width in microseconds.
Enters the remote mode of control.
Exits the remote mode and return DSTS to normal operation.
Sends a simple menu of all commands to the terminal.
Page 8
0=ft, 1=fm, 2=mt
0-255
bot or fsh
awt or mwt
aft or mft
cwo or pul
set or nst
Rev 140930-300