ClearWave CW-125 Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Distributore d'acqua ClearWave CW-125. ClearWave CW-125 10. Water conditioner

OPERATION TIMETABLE

The following timetable should be used to evaluate the operation of the ClearWave during the first 90 days.

DAY 1:

The ClearWave action immediately starts to loosen existing scale in both the hot and cold water systems. One

should find soap lathers more easily.

DAY 5 AND ONWARDS:

Scale begins to break down and come off water heater elements (immersion heaters) and tanks. Most

particles are microscopic and will flow through your water system, but some small particles may be seen in

the water coming from the hot water tap.

DAY 10 TO 16:

It should be noticeably easier to wipe clean ceramic, plastic, glass, and metal surfaces. By now the quantity of bath

soap, dish soap, laundry detergent, and laundry softening agents can be reduced. Scale should have loosened on

faucets, showerheads, and frequently used appliances that boil water (such as coffee makers).

DAY 16 AND ONWARDS:

Scale should continue to loosen from faucets, showerheads, and pipes. With the continuing break down and

reduction of scale from the heating surfaces of water heaters, water should heat up quicker using less energy

to achieve the desired temperature.

AFTER 1 TO 2 MONTHS:

Any scaly crust or stains in toilets or under faucets should be significantly reduced. No new stains or crust should

form. Mold that attaches to scale will begin to disappear from shower curtains and, once cleaned, should not

reappear. Depending on the water hardness in the area, the full effects can take up to 12 weeks, especially if the

system has been heavily scaled up over many years.

Please note: The ClearWave is NOT a water softener and doesn't not REMOVE calcium or magnesium from

the water.

The ClearWave coils should be mounted on the water supply

pipe as it enters the building, before the piping branches off to

supply the water heater and any cold water taps. This allows the

ClearWave to condition all of the water supplied to the building.

The ClearWave should be mounted after any water meter or

grounding cable attached to the water piping system. Install the

ClearWave at least ten feet from any radio, television, or cordless

telephone to eliminate any possible interference.

HOW TO INSTALL THE CLEARWAVE

Figure 1

Mount the ClearWave onto the pipe by routing a wire tie through the two holes on each end of ClearWave

housing base. (See Figure 1) The performance of the ClearWave is not affected by the direction or orientation.

The unit may be mounted horizontally, vertically, or diagonally. The ClearWave can be used effectively on

any type of water pipe; galvanized, copper, or plastic.

page 4