ArtFox Lightning MATRIX 25E Manuale d'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzature per DJ ArtFox Lightning MATRIX 25E. ArtFox Lightning MATRIX 25E 10. Matrix beam wash, artnet, rdm

Stampa la pagina

A. The unit does not work, no light and the fan does not work

1. Check the connection of power and main fuse.

2. Measure the mains voltage on the main connector.

3. Check the power on LED.

B. Not responding to DMX controller

1. DMX LED should be on. If not, check DMX connectors, cables to see if link properly.

2. If the DMX LED is on and no response to the channel, check the address settings and

DMX polarity.

3. If you have intermittent DMX signal problems, check the pins on connectors or on

PCB of the unit or the previous one.

4. Try to use another DMX controller.

5. Check if the DMX cables run near or run alongside to high voltage cables that may

cause damage or interference to DMX interface circuit.

C. One of the channels is not working well

1. The stepper motor might be damaged or the cable connected to the PCB is broken.

2. The motor's drive IC on the PCB might be out of condition.

6. Fixture Cleaning

The cleaning of internal and external optical lenses and/or mirrors must be carried out

periodically to optimize light output. Cleaning frequency depends on the environment

in which the fixture operates: damp, smoky or particularly dirty surrounding can cause

greater accumulation of dirt on the unit's optics.

 Maximum ambient temperature is Ta: 40℃. DO NOT operate it where the

temperature is higher than this Unit surface temperature may reach up to 85℃. DO

NOT touch the housing bare-hand during its operation. Turn off the power and allow

about 15 minutes for the unit to cool down before replacing or serving.

 In the event of serious operating problem, stop using the unit immediately.Never

try to repair the unit by yourself. Repairs carried out by unskilled people can lead to

damage or malfunction. Please contact the nearest authorized technical

assistance center. Always use the same type spare parts.

 DO NOT touch any wire during operation as high voltage might be causing electric

shock.

Warning:

 To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain

or moisture.

 DO NOT open the unit within five minutes after switching off.

 The housing, the lenses, or the ultraviolet filter must be replaced if

they are visibly damaged.

Caution:

There are no user serviceable parts inside the unit. DO NOT open the housing or

attempt any repairs yourself. In the unlikely event your unit may require service,

please contact your nearest dealer.

Installation:

The unit should be mounted via its screw holes on the bracket. Always ensure that the

unit is firmly fixed to avoid vibration and slipping while operating. And

make sure that the structure to which you are attaching the unit is secure and is able

to support a weight of 10 times of the unit's weight. Also always use a safety cable that

can hold 12 times of the weight of the unit when installing the fixture.

The equipment must be fixed by professionals. And it must be fixed at a place where is

out of the touch of people and has no one pass by or under it.