FiTech 50019 Manuale di istruzioni - Pagina 2

Sfoglia online o scarica il pdf Manuale di istruzioni per Pompa dell'acqua FiTech 50019. FiTech 50019 6. Go fuel in-tank retrofit kit

Stampa la pagina

•

Slow Speed Drill Motor

•

4 1/4" Diameter Hole Saw

•

Round fine file

•

Shop Vacuum

•

3/16 Allen Wrench

•

For extended fuel pump life never let car go below 1/8th tank of gas.

•

If using hard fuel lines make sure to use high pressure EFI rated lines and flared

fittings.

•

Make sure that you remove ALL low-pressure flex joints on factory fuel lines and

replace them with EFI rated fuel hose and use proper flared connections and

clamps. Be careful not to mix 45° SAE fitting and 37° AN fittings, they look similar

but will not work together. 45° SAE fittings usually come from a hardware store or

auto parts store while 37° AN fittings are the ones supplied by FiTech and most

speed shops.

•

Use at least a 3/8" ID hose for a return line.

•

FiTech does not recommend aluminum fuel lines EVER! Use EFI high pressure

fuel hose on any plumbing in your system where high pressure is present.

•

If using Push-Lok style hose and fittings in your fuel system, make sure all parts

come from the same manufacturer. Mixing brands of hose ends and hose could

cause leaks.

• FiTech's EFI systems are designed for use with unleaded pump gasoline. Leaded

gasoline is not recommended for safe operation.

•

Relieve the pressure from within the system before opening the fuel system.

• Very important note: Your fuel tank must have a vent or use a vented cap to

prevent pressure building up inside the tank!

Features

The FiTech Go-Fuel In-Tank Pump Module is designed for almost any fuel tank

depending on depth. By mounting the fuel pump in the appropriate position on the

return tube, it can be installed in tanks ranging from 7 to 15 inches in depth. Note that

these instructions and this kit address installation in baffled fuel tanks (Sock Version

#1) as well as stock fuel tanks (Sock Version #2). The system comes with a high flow

fuel pump or pumps. These pump flow 340 LPH which is good for up to 800 HP in

naturally aspirated applications. Properly mount fuel pump with proper fuel tank sock to

ensure clean fuel, extended fuel pump life, and a steady pickup to the pump. If

necessary, replacement parts are available from:

Recommended Tools

IMPORTANT Special Instructions

•

Screwdriver: Flat Head

•

Hack Saw

•

3/8 and 5/16 Wrench

•

9/32" Diameter Drill Bit

(Optional)