Altronics A 4489 Manuale di istruzioni per l'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Microfono Altronics A 4489. Altronics A 4489 8. Paging

Connecting the BGM (Background Music)
Backgound music can be supplied to the paging system by connecting an audio source such as a mobile phone, tablet etc.
to the 3.5mm input jack on the rear of the paging microphone. Figure 7 shows the position of this connector.
To activate the background music, first make sure the Push to Talk (PTT) switch is in the centre position and then select
the zones to receive the background music. The selected zones led indicators will flash to signify they have been selected.
Next move the PTT switch to the up position which is lablelled "Lock On". While the switch is in this position and only this
position will the background music will be piped out to the zones selected.
The volume is adjusted by the BGM volume trimpot on the rear of the microphone.
If the PTT switch is moved to the "Page" position the background music will stop and paging will be active.
If the PTT switch is in the centre position the BGM and paging are not active.
If background music is required again to the same zones as previously selected, then all thats needed to initiate it again is
to move the PTT switch back to the "Lock On" position.
If the BGM is to be piped to different zones then it is only a matter of selecting the new zones, and then moving the PTT
switch to the "Lock On" position.
A 4488
4 Zone Communicator
Lock On
Page
System Busy
TO ACTIVATE THE BGM
MOVE THE SWITCH TO
THE "LOCK ON" POSITION
6
Redback® Proudly Made In Australia
Connecting an audio source to the BGM input
24VDC In
All Call
Cancel
ADJUST THE BACKGROUND
MUSIC VOLUME
DIP Switches 1-2 Settings
BGM
Mic
SW
On
O
BGM
Chime
PA System Chime On
1
PA System Chime O
Input
Volume
Volume
Volume
2
Internal Chime On
Internal Chime O
ON
1 2 3 4
1 2 3 4
REAR OF A 4488
Fig 7
BACKGROUND
MUSIC SOURCE
www.altronics.com.au