AIMS Power PWRINV800W Manuale di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per Inverter AIMS Power PWRINV800W. AIMS Power PWRINV800W 9. Dc to ac power inverter

Make sure the inverter is turned off before installing the remote switch. Plug the
switch into the remote jack and then turn the main switch to the OFF position for the
remote to work properly.

Measuring The AC Voltage

The output waveform of the inverter is a MODIFIED SINE WAVE. If you choose to
measure the AC output voltage, you must use a TRUE RMS MULTI METER. Using any
other type of voltage measuring device will result in an AC voltage reading of 10 to
30 volts lower than actual voltage. When using a true RMS multi meter, you will get
an accurate reading.

SAFETY PRECAUTIONS

Do not open the case of the inverter. The high voltage inside the unit is the same type of
power as your electrical outlets at home.
Do not let the cord of the inverter, or any appliance cord get wet. If you are operating the
inverter in a moving vehicle, we recommend that you secure the inverter to prevent it from
shifting around while the vehicle is moving.
Do not operate this inverter in or around water. Water can damage the inverter, and water
damage is not covered under warranty. Also, do not operate the inverter with wet hands. The
AC voltage of the unit makes it an electrical shock hazard if operated with wet hands.
Allow at least 12 inches of clearance around the Inverter for air flow. Ensure the ventilation
openings on the rear and bottom of the unit are not obstructed.
Do not connect the inverter directly to another AC power source. Damage may result, and
such damage will void the inverter warranty.
Know the wattage requirements of your appliance. Use only those appliances which are
limited by the capacity of this unit.
Use common sense. This device produces power just like your wall outlets at home and
should be treated seriously. Keep it away from children.
Reversed polarity of AC power outlet LINE /NEUTRAL will void the warranty.
If there is anything wrong with the inverter, disconnect all of the power and contact technical
support.