dji Matrice M210 Manuale di integrazione - Pagina 16

Sfoglia online o scarica il pdf Manuale di integrazione per Droni dji Matrice M210. dji Matrice M210 20. Matrice 200 series
Anche per dji Matrice M210: Manuale di avvio rapido (18 pagine), Manuale di avvio rapido (15 pagine)

Stampa la pagina

SYSTEM OPERATION

POWERING THE GEOSNAP PPK SYSTEM

Battery Information

Two Turnigy 9XR 2200mAh 11.1V Li-Po batteries are included for powering the system. These batteries have built-

in undervoltage protection, which means that power will be cut from the output leads if any cell drops below 3.0V

(thus preventing damage to the battery). The advantage of using these batteries to power the GeoSnap PPK (as

opposed to using power from the drone) is that the GeoSnap PPK can keep logging and maintain GPS lock, even if

the drone's batteries needs to be swapped when mapping large areas.

Checking Battery Voltage

You can check the voltage of the entire battery and it's individual cells by plugging in the battery's balance plug

into the connector labeled "3 Cells" on the included DC-4S charger/voltage checker (you can even do this while the

battery is powering the GeoSnap PPK).

A full battery has a total voltage of 12.4V - 12.6V. The battery is practically depleted once has reached 10V. A fully

charged battery can run the GeoSnap PPK for about 6 hours.

Battery Charging

1) Plug in the AC adapter into the wall.

2) Plug in the barrel power plug from the AC adapter into the DC-4S charger/voltage checker. Check to make

sure that 3 dashes are displayed before plugging in the battery (this indicates that there is indeed power

getting to the charger and that it won't just operate as a voltage checker).

3) Insert the balance plug of the battery into the connector labeled "3 Cells". The charger will display the

overall voltage battery and the voltage of each cell as it charges. Charging a fully depleted battery takes

about 2 hours and 30 minutes.

4) Once the battery is fully charged, the charger will display "FUL" and begin to beep. At this point you

should disconnect the battery and unplug the AC adapter from the wall.

Field of View GeoSnap PPK Manual