dji T20 Manuale di avvio rapido - Pagina 16

Sfoglia online o scarica il pdf Manuale di avvio rapido per Droni dji T20. dji T20 17.

FCC/ISEDC Compliance Notice

This device complies with Part 15 of the FCC Rules and ISEDC RSS standard. Operation is

subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2) This device must accept any interference received,including interference that may cause undesired

operation.

Any changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

Ce dispositif est conforme à la partie 15 des règles de la FCC et à la norme ISENC RSS. L'opération est

soumise aux deux conditions suivantes :

(1) Cet appareil ne doit pas causer d'interférences nuisibles, et

(2) Cet appareil doit accepter toutes les interférences reçues, y compris celles susceptibles de

provoquer un fonctionnement indésirable.

Tout changement ou modification non expressément approuvé par la partie responsable de

la conformité peut annuler le droit de l'utilisateur à utiliser l'équipement.

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expense.

RF Exposure Information

Aircraft and HIGH-PRECISION DBF IMAGING RADAR complies with FCC/ISEDC radiation

exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding

the FCC/ISEDC radio frequency exposure limits, human proximity to the antenna shall not be less than

20cm during normal operation.

For Remote Controller (model:RM500-AG),SAR tests are conducted using standard operating

positions accepted by the FCC/ISEDC with the device transmitting at its highest certified power

level in all tested frequency bands, although the SAR is determined at the highest certified power

level, the actual SAR level of the device while operating can be well below the maximum value.

Before a new model is a available for sale to the public, it must be tested and certified to the FCC/

ISEDC that it does not exceed the exposure limit established by the FCC/ISEDC, Tests for each

product are performed in positions and locations as required by the FCC/ISEDC. For Handheld

operation, this device has been tested and meets the FCC/ISEDC RF exposure guidelines when used

with an accessory designated for this product or when used with an acces sory that contains no metal.

For body worn operation, Remote Controller (model:RM500-AG) has been tested and meets

the FCC/ISEDC RF exposure guidelines when used with an accessory designated for this product or

when used with an accessory that Contains no metal and that positions the handset a minimum of 0

cm from the body.