fitness Gallary RX125v3 Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Cyclette fitness Gallary RX125v3. fitness Gallary RX125v3 17.

Stampa la pagina

No.

Name

Fixed bolt for plate

Rubber cover for flywheel

Adjuster cable guide

Sensor cable

Flywheel protection tube

Instruction Use

1) The bike is designed to be used as a "spin " cycle in fitness studios and health clubs. It

has a fixed wheel driven flywheel and should only be used under professional

supervision.

2) Installation – it is important that the bike is correctly assembled and we recommend

that suitably qualified personnel carry out installation and assembly.

3) Handlebar and seat adjustment. It is important that the handlebar and seat are set at

the correct height for your body. Ask your instructor for assistance. Adjusting the

handlebar height-Undo the release lever that is located where the handlebar post fits

into the frame. Slide the handlebar post up or down to the required height and

retighten the release lever. Make sure it is securely tightened and that there is no

lateral or vertical movement of the handlebar. The handlebar position can also be

adjusted forwards or backwards.

handlebar slider. Slide the handlebar assembly forwards and backwards until you

reach the required position. Then securely re-tighten the Release lever.

Adjusting the seat height- undo the release lever located where the seat post fits into

the frame. Adjust the seat to the required height. Then retighten the release lever.

Make sure it is tighten enough to prevent the seat from twisting side to side. The seat

position can be adjusted forwards and backwards. Undo the release lever located

directly side of the seat slider. Loosen the release lever then slide the seat to the

required position. Then make sure the release lever retighten.

4) Pedals and toe straps- your feet should be securely positioned in the toe clips during the

exercise. Put your foot as far forwards as you can into the toe-clip and then pull the

strap tight.

5) The bike should operate on a level surface with no lateral movement. There is height

adjuster pad located on either side underneath of the foot tube. Turn these pads

clockwise or anti-clockwise until the bike is totally stable on the ground.

6) Emergency brake –

lever (24) completely forward.

7) Maintenance – It may be unsafe when loosen bolt on the parts or noise on the flywheel,

please contact your supplier. Like any other mechanical cycling device, the bike

should be regularly maintained.

program.

Unit No.

This bike can be instantaneously stopped by rotating the red tension

Ask your supplier for a detailed maintenance

Name

Bolt for protection tube

Washer for protection tube

Bottom tube cover

G01

Magnetic holder w/magnetic set SET

Undo the Release lever located below the

Unit

w/adhesive

tape