AimSafety PM150-CO2 Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Strumenti di misura AimSafety PM150-CO2. AimSafety PM150-CO2 2. Personal single gas monitor

Stampa la pagina
AimSafety PM150-CO2 Manuale di avvio rapido
AimSafety PM150-CO
Personal Single Gas Monitor
Quick Start Guide
Please refer to the PM150-CO
User Manual for
2
additional product information and features.
www.aimsafety.com
AimSafety
Contact Information
Technical Support
Monday - Friday 8:00 AM to 5:00 PM Central (US) time
Phone (toll-free): 1-844-325-3050
World Headquarters
3601 North St. Paul Avenue
Sioux Falls, SD 57104, USA
Phone: 1-877-367-7891
Fax: 1-605-951-9616
WARNINGS
2
•
Any unauthorized attempt to repair or modify the product, or any other cause of
damage beyond the range of the intended use, including damage by fire,
lightning, or other hazard, voids liability of the manufacturer.
•
Activate this product only if sensor, display screen, and audible cover are clear
from contaminants such as dirt and debris that could block the area where gas is
to be detected.
•
To prevent static electricity build-up, do not clean or rub the LCD screen of the
•
product with a dry cloth or hands while in a hazardous environment.
•
Perform cleaning and maintenance of the products in fresh air that is free of
hazardous gases.
•
Test the response of the sensor regularly with a gas concentration exceeding the
alarm set point.
•
Test LED, buzzer, and vibration manually.
•
Gas concentration measurements from the sensor can vary based on the
environment (temperature, pressure and humidity). Therefore, calibration of
PM150-CO2 should be performed in the same (or similar) environment of the
device's actual use.
•
If the temperature changes sharply during use of the device (e.g., indoors vs
outdoors), the value of the measured gas concentration can suddenly change.
Please use the PM150-CO2 after the gas concentration value has stabilized.
•
Severe vibration or shock to the device may cause a sudden reading change.
Please use PM150-CO2 after the value of gas concentration has stabilized.
Excessive shock to PM150-CO2 can cause the device and/or sensor malfunction.
•
All alarm values are set based on the alarm standard that is required by
international standards. Therefore, alarm values should be changed only under
the responsibility and approval of the administration of the work site where the
instrument is used.
•
Replace the battery and sensor in a clean environment that is free of hazardous
gas.
•
If the CO
concentration reaches 0 ppm, calibration should be performed.
2
CAUTIONS
•
Before operating this device, please read the manual carefully.
•
This device is not a measurement device, but a gas detector.
•
If calibration and self-test fails continuously, please do not use the device.
•
Perform a calibration every 30 days in a fresh air environment.
•
Before use, please check the activation date. If the activation date has passed,
please do not use the device.
•
Clean detectors with a soft cloth and do not use chemical substances for
cleaning.
•
View the serial number on the label at the back side of the device.
(ex, SL0101001)
ex) SL 01 01 001
Rev.: A
2021(Year) 01(Months) 01(Day) 001(Manufacture Order)
Scan this QR code to view the product
page for the AimSafety PM150-CO2
Access the User Manual, Replacement
Parts, Accessories list and more!
Home Screen Navigation
Press the Function Key to
advance through the screens
Product Overview
Display Symbols