djpower X-4LED Manuale d'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzature per DJ djpower X-4LED. djpower X-4LED 8. Co2 jet (single unit)

Foreword

Thank you very much of choosing the DJPOWER X-4 LED Co Jet machine.

Before start operating,we strongly suggest to read the user manual carefully.By

following the instructions in the user manual will ensure your safety while

operating the machine,easily achieve the best effect,as well as understanding

the right way to care for and maintain the machine in order to prolong the product

life cycle.

Products description

X-4 LED CO Jet is a large unique

series.Every device is small and light,which has two control modes,electronic

control and DMX control.It's suitable for all large kinds of place and perform.The

bundling spraying gas column can achieve ten meters,with 27(5W LED),can

change colors freely .

Pay attention to all attentions in the user manual and warning printed

on the device ,and must operate In accordance with the instructions.

Attentions for install

Connecting pipe order: connect the nonrapid piecing first ,then the rapid.

Protect the rapid piecing when connecting,avoid rubbing,striking with hard

goods (like floor), keep piecing clean,or will result in the rapid piecing can't seal.

Because the pressure of pipe is very huge when the machine is working,so the

nonrapid piecing must be screw up by wrench while connecting, otherwise may

cause air leakage.

After connecting pipes, test electric property

connect CO .

Test electric property's method: Test every solenoid valve if has on and

off order by electronic control or DMX control,when solenoid valve on and

off ,it will make a sound.

After testing electric property, prohibit everyone close to gas column right

above,open the valve of the gas bomb slowly.Don't open all the valve quickly,

ought to listening carefully if there is any voice of leakage when you open it

.Ensure there is not air leakage,then open the valve.

If air leakage ,turn off the valve of gas bomb immediately,make sure the gas in

piecing and pipes are all let out,then connect. If air leakage is nonrapid piecing,

aways it's not screwed up.use wrench screw up can resolve. If air leakage is

rapid piecing,aways it's not connect in place.Now you can't connect again

immediately.Firstly separate the rapid piecing ,and wait for over ten minutes,

when it's in normal temperature,then connect.

After open all the valve of gas bomb ,the pressure of gauge display normally

(about 5-7Mpa),if it's too low, mean that the gas is not enough.

One second before the first spray will lesser after connect,it's an normal

gas column machine

of the

with two devices in

machine firstly,if it is fine,