DK SONIC DK-13000TS Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Pulitore a ultrasuoni per gioielli DK SONIC DK-13000TS. DK SONIC DK-13000TS 9.

The indicator will be on when ultrasonic cleaning works, while the machine will

buzz .The indicator will be off when ultrasonic cleaning is finished.

8. Heating Switch:

The heating function can be started or stopped by pressing the"Heating" switch.

When machine is heating ,the Heating indicator will be light, and the actual

temperature display will be flash,

than the actual temperature, the heating function can not be started. Under

working mode, the heating function will start working automatically when the

actual temperature goes down to a value which is 1~2℃ lower than the preset

temperature. In default, the heating function will stop automatically after the

ultrasonic cleaning is finished.

DIFFERENT WAYS OF CLEANING

Gennral Cleaning—

Enhanced Cleaning—

detergent, or any other non-acidic cleaning agents.

Extensive Cleaning--

recommended to use specific cleaning solution associated with ultrasonic cleaners.

WARNING

: Strong acid or alkaline cleaning solution will cause corrosion, rust and

even puncture of tank or machine body. To solve this problem, please dilute the solution

to mild PH or use a special tank made of a specific-graded stainless steel, For example:

use SUS304 tank.

The cleaning solution will deteriorate in effectiveness over time and use. It is important

to regularly change the fluid and carefully wash the inside of the cleaning tank in order

to preserve the effectiveness and longevity of the cleaner. Do not use corrosive or

abrasive cleaning tools to clean the tank which must be wiped down and dried before it

can be re-connected to the electrical supply.

NOTE: If the machine starts to spark, smoke, smell of burnt electrics or displays any

other fault the operator must immediately stop the machine, and isolate it from the

electrical supply and contact the supplier. It is dangerous to use it after that.

use only water to clean under the temperature of about 50℃;

add few drops of standard cleaning solutions, liquid soap, or

removing tarnish, carbon & rust from non-plated metals, it is

while if the preset temperature is not higher