Artison RCC300-SM Manuale di installazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di installazione per Subwoofer Artison RCC300-SM. Artison RCC300-SM 15.

RCC 300 SUBWOOFER MODULE (RCC300-SM)

The RCC 300 Subwoofer Module can be installed into either an:



Artison Pre-Build Box (Volume ≈ 0.6 ft

 Infinite Baffle (i.e. 2x4 stud wall, 16" On Center spacing

greater)

IMPORTANT: In an installation of two RCC300-SM's that are being powered by one

RCC300-SA, both Subwoofer Modules need to be in either Pre-Build Boxes or be in

Infinite Baffles. You cannot connect two RCC 300 Subwoofer Modules that are in

different environments to the same RCC 300 Subwoofer Amplifier.

The front of the RCC300-SM and the grille can be painted. The RCC300-SM comes from the

factory with a paint-shield attached. When painting the RCC300-SM, ONLY paint the grille and

outer edge of the module using the included paint-shield.

subwoofer module. Paint can damage the components which would VOID your Warranty.

The minimum mounting depth for the RCC300-SM is 3¾" (95.5 mm), i.e. a 2x4 stud is 3½" deep

add ¼", ½" or ⅝" thick drywall and the RCC300-SM will fit. The maximum drywall thickness the

RCC300-SM can be mounted in is 1.3125" (33.3 mm).

INSTALLATION WITH AN ARTISON PRE-BUILD BOX

1. Please refer to the Installation Guide included in the Artison Pre-Build Box Carton for

installation instructions for your Artison Pre-Build Box.

2. Using the speaker wire already run inside the Pre-Build Box, manage the speaker wire around

the RCC300-SM.

3. Connect the bare speaker wire ends to the spring-loaded binding posts.

4. Install the RCC300-SM into the pre-cut opening of the Pre-Build Box.

5. Carefully tighten the four dog leg clamps on the RCC300-SM using a #2 Philips Head

Screwdriver.

The grille for the RCC300-SM is held in place by magnets. Simply position the grille on the

front of the module into the recessed area.

NOTE: While installing the subwoofer module make sure that any excess wire is run

properly so that it does not interfere with the driver's operation. The design of

the RCC300-IWPBB is such that there is NO clearance between the back of the

subwoofer module and the back of the box. Be careful that no wires are in this

) SOLD SEPERATELY

at least

DO NOT get paint on the rear of the

(Preferred Installation)

4 feet tall, Volume 1.4 ft