Ain King Advantage Professional Series Manuale operativo - Pagina 3

Sfoglia online o scarica il pdf Manuale operativo per Cappa di ventilazione Ain King Advantage Professional Series. Ain King Advantage Professional Series 17.

Ain King Advantage Professional Series Manuale operativo
SECTION 4
Installing Backsplash
1. If an optional BS Series backsplash will be utilized, this must be installed before
the hood canopy because the hood canopy will cover the backsplash mounting
screws. Refer to the instructions included with the backsplash for installation.
SECTION 5
Wall Mounted Canopy Installation
CAUTION:
ALL DUCTING MUST COMPLY WITH LOCAL AND NATIONAL
BUILDING CODES.
WARNING:
TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
1. Determine the type of ducting you will require (Figure 6).
Horizontal
Wall Cap
Figure 6
NOTE: When the duct termination is similar to that shown in Figure 6 (passing through
the wall to which the hood is mounted) the installation requires special consideration.
Depending upon where the wall studs are located, it may be necessary to cut one
or more of the wall studs and install a header and footer to transfer the load to the
adjacent studs. Additional studs may need to be framed into the opening to attach dry
wall or secure the hood. If this is your situation Air King recommends that you hire a
professional and comply with all applicable codes.
2. Install the proper sized outlet adapter (available separately) to the hood by matching
up the four holes on the flange of the adapter to the four corresponding holes on the
hood and secure in place with the provided screws. Ensure an airtight seal around
the adapter by securing all connections with ducting tape (Figure 7).
Outlet Adapter
Hood
Figure 7
NOTE: If the recommended, optional BS Series backsplash is being installed, use
the template to locate and drill the appropriate holes for mounting. The back splash
must be installed before the hood canopy because the hood canopy will cover the
backsplash mounting screws. Refer to the instructions included with the backsplash
for complete installation instructions.
3. Rest the cavity in the back side of the hood on the wood strip and secure hood to
wood strip with the included 3/4" screws through the holes in the back of the hood
that line up with the wood strip (use 6 screws for 30" and 36" widths and 8 screws
for larger widths) Secure the bottom of the hood by installing the screws provided
into the wall anchors (Figure 8).
A111597016 Rev. B 3-10
Roof Cap
Outlet
Adapter
Screw
Flange
Mounting
Wall Anchor
Figure 8
4. Connect the ducting to the outlet adapter and damper. Secure in place using tape
to seal all joints (Figure 9).
Outlet Adapter
Hood
Figure 9
SECTION 6
Under Cabinet Canopy Installation
1. If the canopy will be installed under cabinets that have a recessed bottom, it will
Vertical
be necessary to install wood mounting strips (not included) so the canopy will
mount properly (Figure 10).
Wood Strip
Figure 10
2. The thickness of the strips should be the same as the recess of the cabinet and
they should be approximately 2" wide.
3. Install the strips using appropriate length wood screws (not included). Make sure
the strips line up to the holes in the top of the canopy.
4. Mark the location where the outlet adapter (available separately) will be located
on the cabinets and cut a hole approximately 1" larger on all sides than the outlet
adapter (Figure 11).
Figure 11
www.airkinglimited.com
Wood
Strip
Hole
Screw
Hood
Ducting
Damper
3 of 16