Customidea GeoPic II Manuale di istruzioni - Pagina 12
Sfoglia online o scarica il pdf Manuale di istruzioni per Camera Accessories Customidea GeoPic II. Customidea GeoPic II 20. Geotagging device for nikon d200/d2hs/d2x/d2xs fuji s5 pro
Stampa la pagina11
Freeze mode (blue)
To start a search for a new position, press the function
button on the GeoPic II. This will cause the GPS module
inside the GeoPic II to be powered up, until a new lock is
achieved. The new GPS location will be buffered and the
internal GPS module will switch off once more. The
search for a new position can be cancelled by pressing
the function button whilst the search is taking place, at
which point the last buffered location will be reloaded
into the buffer. If a search is cancelled when there is no
previous data available (e.g. when you first receive the
unit) then the GeoPic II will ignore the cancel request
and continue to search.
By default the GeoPic II will begin a new search when
powered up in freeze mode. If you want to retain the last
location you can cancel this search with the function
button as just described. However, if required, the
GeoPic II can be configured to not search by default on
power up in freeze mode (see the settings section).
In freeze mode, the short beep and lighting of the blue
light indicates that sufficient buffered GPS data has
been sent to the camera for it to start geotagging photos.
There will be a fraction of a second delay from the
moment you press the shutter release button half way
until the camera is ready to geotag the photo. Therefore
you must wait until the blue status light is lit before
taking your photo. A beep coincides with the blue light
meaning that you do not need to take your eye from the
camera viewfinder to know that the camera is ready.
This is identical operation to the low power (green) mode,
except the GeoPic II uses buffered, not live GPS data.
Nikon D200, D2HS, D2X and D2XS and Fuji S5 Pro are registered
trademarks or a trademark of their respective companies.