Alula RE103P Manuale d'istruzione e d'uso - Pagina 2
Sfoglia online o scarica il pdf Manuale d'istruzione e d'uso per Sistema di sicurezza Alula RE103P. Alula RE103P 2. User instructions
Stampa la pagina
Zone 1
Single Tap
Press and Release
(Once)
Zone 2
Double Tap
Press and Release
(Twice, <1 second
apart)
Zone 3
Press and Hold
Press and Hold (5 seconds)
Then release
The LED Ring blink patterns confirm each button press type detected:
Zone 1
Single Tap
One short blink +
On for 3 seconds
Zone 2
Double Tap
Two short blinks +
On for 3 seconds
Zone 3
Press and Hold
Three short blinks +
On for 3 seconds
The LED will remain on for approximately 3 seconds when transmitting.
Wait until the LED is OFF before attempting the next button press.
A Zone event transmission is sent as an Open immediately followed by a
Restore. Depending on the security panel's features, triggering each of
the Panic Button's Zones can be set up as the initiating action to trigger a
pre-configured automation or rule. Refer to your specific panel's
instructions for more information.
8. Maintenance - Replacing the Battery
When the battery is low, a signal will be sent to the control panel.
To replace the battery:
•
Insert a plastic pry tool, or a small flat blade screwdriver into one of the
notches on the back of the Panic Button and gently pry to release the back
cover from the main housing.
•
Set the back cover aside, and gently remove the circuit board from the
housing.
•
Remove the old battery and insert a new Panasonic CR2032 battery with
the positive side (+) of the battery touching the battery holder marked
with the (+) symbol.
Re-assemble by placing the circuit board into the back case with the
•
battery side facing down. Align the small notch on the side of the circuit
board with the tallest plastic rib on the inside wall of the back case. When
properly inserted, the circuit board will sit level inside back case.
•
Align the arrows of back cover and the main housing, then carefully snap
them together.
•
Test the Panic Button to ensure proper operation.
WARNING: Failure to follow these warnings and instructions can lead to heat
generation, rupture, leakage, explosion, fire, or other injury, or damage. Do
not insert the battery into the battery holder wrong side up. Always replace
the battery with the same or equivalent type (see Specifications on page 1).
Never recharge or disassemble the battery. Never place the battery in fire or
water. Always keep batteries away from small children. If batteries are
swallowed, promptly see a doctor.
Always dispose and/or recycle used batteries in accordance with the
hazardous waste recovery and recycling regulations for your location. Your
city, state, or country may also require you to comply with additional
handling, recycling, and disposal requirements.
Product Warnings and Disclaimers
WARNING: CHOKING HAZARD - Small parts. Keep away from children.
WARNING: STRANGULATION AND CHOKING HAZARD – A user can suffer serious
personal injury or death if the cord becomes entangled or stuck on objects.
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Re-orient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment to an outlet on a different circuit from the receiver
•
Consult the dealer or an experienced radio/TV contractor for help.
Warning: Changes or modifications not expressly approved by Alula could void the user's authority to
operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
C'et appareil est conforme la norme d'Industrie Canada exempts de licence RSS. Son fonctionnement est
soumis aux deux conditions suivantes: (1) c'et appareil ne peut pas provoquer d'interférences, et (2) c'et
appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais
fonctionnement de la dispositif.
FCC ID: XQC-WST131
IC: 9863B-WST131
Trademarks
Apple Watch is a registered trademark of Apple Inc.
All trademarks, logos and brand names are the property of their respective owners. All
company, product and service names used in this document are for identification purposes
only. Use of these names, trademarks and brands does not imply endorsement.
Warranty
Ecolink Intelligent Technology Inc. warrants that for a period of 2 years from the date of
purchase that this product is free from defects in material and workmanship. This warranty
does not apply to damage caused by shipping or handling, or damage caused by accident,
abuse, misuse, misapplication, ordinary wear, improper maintenance, failure to follow
instructions or as a result of any unauthorized modifications. If there is a defect in materials and
workmanship under normal use within the warranty period Ecolink Intelligent Technology Inc.
shall, at its option, repair or replace the defective equipment upon return of the equipment to
the original point of purchase. The foregoing warranty shall apply only to the original buyer, and
is and shall be in lieu of any and all other warranties, whether expressed or implied and of all
other obligations or liabilities on the part of Ecolink Intelligent Technology Inc. neither assumes
responsibility for, nor authorizes any other person purporting to act on its behalf to modify or
to change this warranty, nor to assume for it any other warranty or liability concerning this
product. The maximum liability for Ecolink Intelligent Technology Inc. under all circumstances
for any warranty issue shall be limited to a replacement of the defective product. It is
recommended that the customer check their equipment on a regular basis for proper
operation.
Ecolink is a trademark owned by Ecolink Intelligent Technology Inc.
RE103P Designed and manufactured by Ecolink Intelligent Technology Inc. 2022.
© 2022 Ecolink
2055 Corte Del Nogal
Carlsbad, CA 92011
1-855-632-6546
www.discoverecolink.com
PN: 47007-00xxxxx
© 2022 Ecolink Intelligent Technology Inc.
REV & REV Date: A01 10/12/2022