Alula RE657 Manuale - Pagina 8

Sfoglia online o scarica il pdf Manuale per Pannello a sfioramento Alula RE657. Alula RE657 12. Connect+ encrypted

Stampa la pagina
Pro Tips
To remove the Touchpad feet, open the enclosure and remove the tablet. Then
locate and depress the locking tab while sliding the foot off the enclosure.
Always ensure the power cable is properly routed through the strain relief
channels when reassembling the Touchpad.
The Touchpad display turns off on its own after specified allotted time of inactivity
(Auto sleep display setting). It will turn back on when the screen is touched, or for
some alarm conditions. The screen can also be turned off manually by pressing
"Sleep."
The power supply MUST be secured to an outlet if installed in the USA.
The power supply MUST NOT be secured to an outlet if installed in Canada.
The Touchpad volume can be changed in the Settings screen. The physical volume
rocker switch on the top left side of the Touchpad is not enabled.
The Touchpad can be rebooted by holding the power button on the top left side of
the Touchpad for several seconds; however, this should never be required.
To unenroll the Touchpad navigate to the Settings menu and then to the section
labeled "Panel." Put the panel into wireless enrollment mode and press the
unenrollment button. Note: The unenrollment button is displayed only when in
enrollment mode.
The Touchpad's power cable can be extended by splicing in a longer wire. To do
this first unplug the adapter from the wall. Next cut the power wire 16 inches
from the USB connector and 6 inches from the transformer. Discard this section of
wire and replace it with the desired wire length per the table below.
Locking Tab

WIRE GAUGE

18
16
14
16"

MAXIMUM LENGTH

13 feet
20 feet
31 feet
New
Wire
Here
6"