Alumax ProLine PL50 Manuale di istruzioni per l'installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Involucro Alumax ProLine PL50. Alumax ProLine PL50 8. Frameless sliding enclosure

Stampa la pagina

Set the header bar and stopper assembly into the

wall mount bracket, from the top. Slide a Wall Mount

Cover [G] into the wall mount bracket. Tighten the wall

mount, and wall mount cover set screws [H] until the

header bar is secure. This will prevent rattles in the

header bar.

Locate the center of the sill at the middle of the

header bar. From the Center Guide [I] remove the

two Center Guide Inserts [J] to expose the mounting

holes. Using the center guide as a pattern, mark the

location for the two holes and lightly trace the outline of

the center guide on the sill. Drill two 5/16" holes. A little

silicone in the holes will help seal the holes and prevent

moisture from entering the sill. Place the center guide

anchors into the holes. Put a small bead of silicone

around the interior of the outline for the center guide.

Set the center guide in place and secure it with the two

Center Guide Screws [K]. Replace the center guide

inserts with the thicker legs to the inside of the center

guide.

Place the male portion of a Roller Cap [L] into a

top hole in a glass panel, in a neutral position as

shown. Attach a Roller [M] to the cap, using a Roller

Screw [N]. Screw the threaded Roller Cover [O] onto the

cap. Repeat for the other three top holes. The lower four

rollers will be installed later.

NOTE: The door glass can be adjusted, up or down, later

by removing the roller cover, loosening the roller screw

and rotating the cam action roller cap.

Page 5 of 8