Alumax ProLine PL70 Manuale di istruzioni per l'installazione - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Involucro Alumax ProLine PL70. Alumax ProLine PL70 8. Heavy frameless bypass bath enclosure

Stampa la pagina

Seal Installation – Cut the Bulb Vinyl [LL] to the vertical length

of your Door Glass. Cut the Panel Seal [MM] to the vertical

length of the door glass minus 4". Press the Bulb Vinyl on the strike

side of the Door Glass and the Panel Seal on the other, below the

Header Bar. A small amount of silicone can be used between the

glass and seal if you like.

Set the Stops – Move the door to the closed position. Slide

the Stopper [AA] over until it touches the roller on the strike

side of the door. Tighten the Stopper Set Screw [BB]. Move the

door to the open position with the handle 1/4" - 1/2" from hitting

the fixed panel. Slide the other stopper over until it just touches the

roller on the fixed side of the door. Tighten the Stopper Set Screw.

Finishing Up – Make sure that all fasteners are tight. Clean

all exposed marks you made on the sill and walls of the

shower stall. Clean the glass panels.

Allow 24 hours for any silicone to completely cure, before

using your new Alumax Shower Door.

Page 9 of 9