Alumax Stickstall 794 Series Manuale di istruzioni per l'installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Cabine doccia Alumax Stickstall 794 Series. Alumax Stickstall 794 Series 11. Shower enclosure

Stampa la pagina

- 790 DOORS ONLY

Strip two clear vinyl jamb seals [L] into the

door panel [M] splash guard and the pivot jamb

[N] and trim flush at the ends. Both vinyls should

be turned to trap water from the shower head.

Secure the vinyls with a small quantity of glue or

caulk at each end or by carefully crimping the

vinyl pocket.

Set the door panel aside.

Press the pivot jamb and strike jamb [P] (with

magnetic strip) over the two 135° posts [K]. Refer

to Step #1 for the proper handing of the door.

NOTE:

The magnetic strip on the strike jamb

must face the exterior and the clear vinyl jamb

seal on the pivot jamb must face inward.

- 790 DOORS ONLY

Snap the fillers [R] into the curb assembly

[A] and header assembly [D] between the door

jambs with the raised lip to the exterior and the

pivot holes toward the pivot jamb. Center the curb

filler in the curb between the pivot and strike

jamb (use masking tape to hold in position).

NOTE:

The snap-in fillers should be exactly 3/8"

longer than the door panel width.

- 790 DOORS ONLY

Pull the bottom end of the pivot jamb [N]

tight to the curb filler [R] and plumb the jamb.

Drill two 1/8" holes thru the pivot jamb and into

the 135° post [K] in line with the screws in the

header and approximately 1/4" vertically from the

ends of the jamb.

between the first two and enlarge the outer holes

with a 3/16" drill for clearance on the self-tapping

screws.

Attach the pivot jamb permanently with

three #8 x 1/4" truss head screws [C].

Slide the header filler [R] tight against the pivot

jamb.

Push the strike jamb [P] tight against the

fillers top and bottom.

and both fillers tight between the two door jambs,

the strike jamb also will be plumb and parallel to

the pivot jamb. Attach the strike jamb to the other

135° post in the same manner as the pivot jamb.

Drill a third hole centered

With the pivot jamb plumb

Page 7 of 11

EPH-N00-06003

5-20-97