Aluprof DC 448 Manuale di programmazione - Pagina 4
Sfoglia online o scarica il pdf Manuale di programmazione per Trasmettitore Aluprof DC 448. Aluprof DC 448 4.
Anche per Aluprof DC 448: Manuale di programmazione (4 pagine)
Stampa la pagina
2.3. Settings days and hours for automatic controls
Programming of the timer for the automatic controls can be performed only in automatic or random mode.
If there will be a bigger interval during the programming than 10 seconds the timer will go from the setting mode out.
Press and hold the „P2" button for 2
seconds to switch the automatic control
mode to the random control mode
By pressing the „MODE / K-" -button you
can change to the minutes settings
By pressing the „OK / K +" button we
confirm the changes and go to the
settings of the reduction times
4
DC 448 PROGRAMMING MANUAL
Hold down the „MODE / K"
button for 5 seconds to display the hour
symbol (raise).
The operation of the "UP" and „DOWN"
keys changes the minute settings
The operation of the „UP" and „DOWN"
keys changes the hour settings
Press the „OK / K +" button to accept and
save all the changes you have made and
at the same time go to the settings of the
next sender channel
Press the „MODE / K -" key again so that
the hour symbol starts to flash.
By pressing the „MODE / K-" -button you
can switch to changes in the weekday
settings
By pressing the „MODE / K-" -button you
can change to the minutes settings
The operation of the „UP" and „DOWN"
keys changes the hour settings
The operation of the „UP" and „DOWN"
keys changes the day of the week
settings.
The operation of the "UP" and „DOWN"
keys changes the minute settings
When all the necessary changes have
been made and the setting function has
to be exited then we press the „Stop"
button which switches the transmitter to
the operating control mode.
We reserve the right to any technical change. Valid on 2019.03.13