Aluprof DC 448 Manuale di programmazione - Pagina 3
Sfoglia online o scarica il pdf Manuale di programmazione per Trasmettitore Aluprof DC 448. Aluprof DC 448 4.
Anche per Aluprof DC 448: Manuale di programmazione (4 pagine)
6. SETTING OF THE AUTOMATIC CONTROL TIME
It is possible to set the days of the week in automatic control in three modes:
1. Selected day of the week, 2. Working days, 3. Working days and Saturday, 4. The whole week
Switch to automatic or
random mode.
Press the "MODE / K-" button.
Minutes digits will flash.
Press the "OK/OK+" button. The
lowering hour will be displayed.
Hour digits will flash.
Press the "OK / K +" button
to confirm the settings and
switch to the next channel.
The symbol "- - : - -" in the automatic control time settings means that the control is not active.
To automatically control receivers from all the channels seting up a group channel on the transmitter is required.
Group channel is active when all channels numbers are highlighted.
In the auto mode interval between lifting and lowering time cannot be less than 32 minutes, otherwise the display will
show "ER:01" error.
We reserve the right to any technical change.
Valid on 2022.02.09
INSTRUKCJA PROGRAMOWANIA NADAJNIKA DC448
Press and hold "MODE/K -"
button for 5 seconds. The lifting hour
will be displayed.
By pressing the "UP" or "DOWN"
buttons, settings of the
minutes can by change.
By pressing the "UP" or "DOWN"
buttons, you can
change the hour settings.
Repeat the above steps to
set the hours for other
channels.
Press the "MODE/K -" button again.
Hour digits will flash.
Press the "MODE / K-" button.
Week days will flash.
Press the "MODE / K-" button.
Minutes digits will flash.
Press the "STOP" button
to save the
changes made.
By pressing the "UP" or "DOWN"
buttons, you can
change the hour settings.
By pressing the "UP" or "DOWN"
buttons, settings of the
week days can by change.
By pressing the "UP" or "DOWN"
buttons, settings of the
minutes can by change.
Changes have been saved.
The display shows the current
time
3