Cutting SQ50E Manuale di avvio rapido - Pagina 6

Sfoglia online o scarica il pdf Manuale di avvio rapido per Utensile elettrico Cutting SQ50E. Cutting SQ50E 7. Pipe threading machine

9. Tighten clamp lever.

10. If oversize or undersize threads are required, set the index line in direction of OVER or

UNDER size mark on size bar.

Threading Operation

Fig 3

Relevant parts' name, please refer to the photos within this manual.

1. Install die set. Refer to dies Installation procedure above.

2. Swing cutter and reamer to UP position.

3. Swing die head to DOWN position with throwout lever set

to CLOSE position.

4. Switch on the threader. Oil should flow from die head.

5. Turn carriage handwheel to bring dies against end of pipe.

Exert pressure on handwheel to start dies.

6. When die head end of pipe contacts trigger, throwout lever

is automatically opened on tapered threads.

7. Switch off power and turn carriage handwheel to back die

head off. Swing the die head to UP position.

Pipe cutting

Fig 4

Relevant parts' name, please refer to the photos within this manual.

1. Swing reamer and die head to UP position.

2. Move pipe cutter DOWN onto pipe and move carriage with

handwheel to line up cutter wheel with mark on pipe.

3. Tighten cutter feed screw handle on pipe keeping wheel

aligned with the pipe.

4. Grasp the pipe cutter's feedscrew handle with both hands

(Figure 4).

5. Switch on the machine.

6. Tighten the feedscrew handle slowly and continuously until

the pipe is cut. Do not force the cutter into the pipe.

7. Switch off the machine. Swing pipe cutter back to the UP

position.

Fig 5

Pipe Reaming

Relevant parts' name, please refer to the photos within this

manual.

1. Move reamer arm into DOWN position.

2. Switch on the machine. Advance reamer into pipe and

complete reaming by exerting pressure on handwheel

(Figure 5).

NOTE! Do not apply excessive pressure on handwheel.