dlb AIJGO-61 Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Strumenti di misura dlb AIJGO-61. dlb AIJGO-61 10. Resistance meter

Turning on

Turn on the device with the "On/Off" button. After switching on, a text similar to the

following appears on the screen containing the device's data:

This is visible for 10 seconds. If you do not want to wait this time, but want to move

on faster, press any button except "On/Off". You will then see a screenshot similar to

the one below:

Measuring voltage

Temperature

Measurement

The AIJGO-61 is suitable for measuring a wide resistance range, between 2 Ω and

1 TΩ. This also enables the measurement of equipment grounding resistance and

the resistance of ESD protective worksurfaces to ground. Thus there is no need

to use other resistance meter during ESD qualification or compliance verification

measurements.

Press and hold the "Measure" button until the measurement result is displayed. This

will remain visible until you press the "Measure" button again.

...MEASURING...

24.5°C

When measuring temperature and humidity, make sure that you do not cover the

sensor on the bottom of the device with your hands or other objects, and do not

place the device on a cooled or heated surface, as this may affect the measurement

results.

The measurement results can be stored by pressing and holding the "MODE" button,

after this a message is shown on the display for 3 seconds. If any blank space is still

available in the measurement list, a message similar to the following will be displayed:

AIJGO-61

RESISTANCE METER

S/N: 1234

Ver: v1.02

_____

10V

24.5°C

100V

42.1%RH

187 MΩ

100V

24.5°C

42.1%RH

Place to display the

resistance value

Relative Humidity