DLG DI-216 Manuale d'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di prova DLG DI-216. DLG DI-216 10. Automotive battery system tester
Stampa la pagina
USER MANUAL
following picture and accompanied by a beep prompt and flash
screen.
generator output current voltage
generator output lowest voltage
(7)Press <ESC> to return step (3).
5-3-3 There are some problems in the system
★ If the voltage is high than 15.00V, please check the voltage
regulator.
★ If the voltage is lower than 13.30V, please check the
connections, wires and the engine.
Data Reference Table
Status
Headlights and
air- condition off
( need to step the gas
pedal when checking)
Headlights and
air- condition on
(need to step the gas
pedal when checking)
The result can be affected by the defective battery.
generator output highest voltage
(12V system)
Voltage
Condition
>13.5
normal
general
13.2~13.5
13.0~13.2
pay attention
<13
check immediately
13.4~14.6
normal
13.2~13.4
pay attention
<13.2
check immediately
10
★ Life check OK, and voltage check low
The result indicates the battery is good and full of 100% of
life. But only 12.11V left. SO suggest charging.
★ Life check OK, and voltage check over low
The result indicates the battery remain only 11.88V left and
over low voltage, which can affect the result. At this time it is
better to charge prior to checking again.
5-2 Engine system activation load test
5-2-1 Preparation
If the engine is working, please turn off first and switch the
key to off location.
5-2-2 Procedure of operation
(1)Connect the red clamp to the positive polar of the battery,
and the black one to the negative polar. Make sure they are well
connected in order to avoid affected result.
(2)Press <▲><▼> to select activation load test as the picture
below:
BATTERY SYSTEM TESTER
7