ALUZ ZUDA Manuale di installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione per Apparecchiature di illuminazione ALUZ ZUDA. ALUZ ZUDA 13. Tape

Measure area where lightstrip will be installed. Use a laser line to

create a reference line along installation area, ensuring consistent

alignment of mounting clips. Mark location where each mounting

clip will be installed along reference line.

Remove adhesive backing from lightstrip and stick in place along

reference line, ensuring lightstrip is securely mounted and free of

twists, tangles, creases, bumps, or overlaps.

For Dry Location applications, only use the mounting clip with the

flat side facing down.

Use 1 mounting clip every 6", rounded up. Use 1 mounting clip every

4", rounded up if application is downward facing, outward facing,

or vertically mounted. Lay mounting clips and pre-drill using an

appropriate drill bit for surface material and screw size.

Recommendation: 8/32 x 1" screw.

1170 N Red Gum St, Anaheim, CA 92806

aluz.lighting

A8 Series | Tape

ZUDA Tape

(A8-ZUDA-TAPE)

866.ALUZ.LTG | 714.535.7900

Screw mounting clips to surface, securing lightstrip to surface.

Note: Do not install clips over LED diodes.

Always use a mounting clip at the very beginning and very end of

each run.

If applicable, connect disconnects between luminaires or solder

connectors using the steps on Application Guidelines.

Perform a continuity test before connecting to power source.

Refer to Continuity Test for details.

Page 6 of 12

Mounting Lightstrip

(Dry Location Mounting Clips)

8/32

Installation Instructions

8 / 11 / 2023 / Rev 1