Alva GHP16 Manuale di istruzioni - Pagina 14

Sfoglia online o scarica il pdf Manuale di istruzioni per Riscaldatore a gas Alva GHP16. Alva GHP16 17.

Stampa la pagina

CHANGING YOUR CYLINDER

Bullnose

regulator

9kg Cylinder

Fig.L

DO NOT attempt to remove the regulator while the heater is on

or if the cylinder valve is not closed.

•

Always make sure the heater is OFF and cool, with the cyl-

inder valve closed, before conducting any maintenance.

•

Your heater should be checked once a year by a qualified

technician.

•

If faults are suspected or detected, stop using the heater

and contact ALVA.

•

Clean the exterior and storage area of your heater when

required to remove dust.

•

DO NOT use abrasive products to clean the heater; these

may damage the paint work.

•

Check the burner and remove any debris, dirt, spider webs

or wasp nests from the burner ports by using compressed

air or a pipe cleaner. DO NOT clean the burner with water

or tamper with the jets. If a jet is blocked it must be replaced

with an original manufacturer marked jet.

•

Replace parts and allow the heater to dry properly before

storing.

•

If the gas control or ignitor is exposed to water or gets wet,

dry it properly before attempting to light the heater. You

might have to replace the parts if the heater does not ignite.

Make sure the cylinder valve is

closed (by turning it clockwise).

Allow the heater to fully cool before

replacing the cylinder. Open the

heater to expose the cylinder.

Lift up the tank housing and tilting

it so that the tank housing support

holds the tank housing up, exposing

the cylinder fully. Allowing you to

access and replace the cylinder.

(Figure L)

Remove and replace the cylinder.

ALWAYS check that the regulator-

sealing washer (nose cone) is intact

and in place before reattaching the

regulator to a cylinder. (Figure B -

Page 3)

MAINTENANCE