Lamp Operation:
The following symptoms may indicate a lamp in need of replacement:
• LAMP indicator lights up red.
• "CHANGE THE LAMP" message appears on the screen.
•
To reduce the risk associated with environmental contamination due to
mercury in the projection lamp:
-
Dispose of lamp cartridge in accordance with applicable federal, state and local regulations.
-
The lamp in this product contains mercuy. Dispose of projection lamp in a manner
that is consistent with your local hazardous waste regulations for mercury.
-
For recycling and disposal information, contact your respective governmental
agencies.
In U.S., contact the Electronic Industries Alliance at www.lamprecycle.org
In Canada, contact the Electronic Product Stewardship Canada at www.epsc.ca
Display Lamp Operation Hours
To determine the lamp operation hours, follow these steps:
1. While the projector is running, press the MENU button on the remote control.
Choose the "OPTION" using the
Choose the "LAMP TIME" using the
2. The operating time of the lamp will be displayed. The message "CHANGE THE LAMP,
AFTER REPLACING LAMP RESET THE LAMP TIMER" will appear after the lamp
operating hours have reached the end of the normal lamp life. The message "POWER
WILL TURN OFF AFTER 20 HOURS" will appear when 20 or less lamp hours remain.
The number of hours left until shut down will decrease until 0 hour is reached, then
power will be turned off.
After normal lamp operating time has expired, the projector will only run for 10-minute
intervals when restarted until the lamp is replaced and the lamp timer is reset. The message
"CHANGE THE LAMP" will blink at projector start up to remind you to change the lamp.
Reset Lamp Hours
1.
While the projector is running, press the MENU button on the remote control.
Choose the "OPTION" using the
button.
2. Choose the "LAMP TIME" using the
the remote control or the
3. The reset menu will then appear. After you replace the lamp with a new lamp, select
"RESET" on the menu with the
10
Lamp
WARNING
button, and press the
√ Note
button on the projector for 3 seconds.
button.
3M™ Digital Projector S15/X15 Product Safety Guide
button or the ENTER button.
button.
button, and press the
button, and press and hold the RESET button on
button or the ENTER
© 3M 2005
Stampa la pagina