AKO AKO-59821 Manuale di istruzioni

Sfoglia online o scarica il pdf Manuale di istruzioni per Strumenti di misura AKO AKO-59821. AKO AKO-59821 2.
Anche per AKO AKO-59821: Istruzioni (2 pagine), Istruzioni (2 pagine)

Stampa la pagina

5981H002 Ed.01

Instrucciones

AKO-59810

AKO-59820

AKO-59811

AKO-59821

Warnings

-If the device is used without adhering to the manufacturer's instructions, the device safety requirements could be compromised. Only probes supplied by AKO should

be used for the appliance to operate correctly.

-The device should be installed in a place protected from vibrations, water and corrosive gases, where the ambient temperature does not exceed the value indicated in the

technical data.

-For the reading to be correct, the probe should be used in a place without heat influences apart from the temperature you want to measure or control.

-Avoid installing the device on metal walls or near devices that may cause radio emissions.

-AKO-59811x / 59821x devices should NEVER be operated without installing the external antenna.

-This device can be fitted with any antenna provided it has a gain of less than 9.2 dBi and there is a minimum distance between it and any person or animal of more than 20 cm.

-This device must always be installed in an area where a minimum distance of 20 cm from the human body is ensured, to guarantee compliance with human exposure to

electromagnetic fields.

-Any type of antenna used with the equipment must comply with the limits established in the radio interface of the member estates and the following documents: Commission

Decision 2010/267/EU of 6 May 2010, ECC Decision (09)03 of 30 October 2009 and CEPT Report 30 of 30 October 2009.

-This device is powered by a non-rechargeable battery, if it runs out it must be replaced with the model AKO-58030. The dead battery cannot be disposed of with household

waste, it must be taken to a select collection point. NEVER try to recharge the battery, perforate or hit the battery or immerse it in liquids or

dispose of the battery with fire.

Installation

Installation conditions: Install the device away from draughts and condensation. Do not locate it close to evaporators, condensers or other items that may

produce electromagnetic noise. If it is installed in a chamber, locate it as close as possible to the door. If it is installed inside a cabinet or any other piece of

furniture, locate it as close as possible to its door.

Ø 2,8 mm

Description

Temperature and moisture monitor with built-in NBIoT communication. Logs temperature and moisture data and

transmits it to the cloud (akonet.cloud). Both the configuration and monitoring of the data are carried out in the cloud

itself.

Display and analysis of the logged data

Both the display of the logged data and the device configuration must be done in the

The portal also allows you to analyse the stored data using graphs, statistics and operating indicators. For more

information visit

akonet.cloud.

Declaration of conformity

AKO Electromecánica S.A.L. hereby declares that the type of radioelectric device AKO-598xxx (Temperature and moisture monitor,

external NTC probe, battery and built-in NB-IoT) is in accordance with Directive 2014/53/EU.

The full text of the EU conformity declaration is available at the following Internet address:

http://help.ako.com/assets/uploads/DUEC598xxx.pdfSimplifi

Option A

Fixing by screws

Ø 5 mm

Only

AKO-59811x /

AKO-59821x

Option B

Fixing by adhesive

3 6

m m

7 0

m m

akonet.cloud. portal.