AKO AKO-59911 V2 Istruzioni

Sfoglia online o scarica il pdf Istruzioni per Strumenti di misura AKO AKO-59911 V2. AKO AKO-59911 V2 2.

AKO AKO-59911 V2 Istruzioni
5991H102 Ed. 01
Instructions
AKO-59911 V2
Warnings
-If the device is used without adhering to the manufacturer's instructions, the device safety requirements could be compromised. Only probes supplied by AKO
should be used for the appliance to operate correctly.
-The device should be installed in a place protected from vibrations, water and corrosive gases, where the ambient temperature does not exceed the value indicated in
the technical data.
-For the reading to be correct, the probe should be used in a place without heat influences apart from the temperature you want to measure or control.
-Avoid installing the device on metal walls or near devices that may cause radio emissions.
-The device should NEVER be operated without installing the external antenna.
-This device can be fitted with any antenna provided it has a gain of less than 9.2 dBi and there is a minimum distance between it and any person or animal of more than
20 cm.
-This device must always be installed in an area where a minimum distance of 20 cm from the human body is ensured, to guarantee compliance with human exposure to
electromagnetic fields.
-Any type of antenna used with the equipment must comply with the limits established in the radio interface of the member estates and the following documents: Com-
mission Decision 2010/267/EU of 6 May 2010, ECC Decision (09)03 of 30 October 2009 and CEPT Report 30 of 30 October 2009.
-This device is powered by a non-rechargeable battery, if it runs out it must be replaced with the model AKO-58030. The dead battery cannot be disposed
of with household waste, it must be taken to a select collection point. NEVER try to recharge the battery, perforate or hit the battery or immerse it in liquids
or dispose of the battery with fire.
Installation
Installation conditions: Install the device away from draughts and condensation. Do not locate it close to evaporators, condensers or other items that may pro-
duce electromagnetic noise. If it is installed in a chamber, locate it as close as possible to the door. If it is installed inside a cabinet or any other piece of furniture,
locate it as close as possible to its door.
2
1
x2
Ø 2,8 mm
4
Description
en
Temperature and moisture monitor with built-in NBIoT communication. Logs temperature and moisture data and
transmits it to the cloud (akonet.cloud). Both the configuration and monitoring of the data are carried out in the
cloud itself.
Display and analysis of the logged data
Both the display of the logged data and the device configuration must be done in the
The portal also allows you to analyse the stored data using graphs, statistics and operating indicators. For more
information visit akonet.cloud.
Simplified declaration of conformity
AKO Electromecánica S.A.L. hereby declares that the radioelectric device types AKO-59911 (Temperature and mois-
ture monitor) conform to the provisions set forth by Directive 2014/53/EU.
The full text of the EU conformity declaration is available at the following internet address:
https://help.ako.com/en/manuals/declaracion-ue-de-conformidad
Option A
Fixing by screws
3
x2
+
Ø 5 mm
Option B
Fixing by adhesive
3 6
m m
7 0
m m
3
.2
3
.1
5
akonet.cloud
portal.
3
.3