DNP DS80 Riferimento rapido - Pagina 3

Sfoglia online o scarica il pdf Riferimento rapido per Stampante DNP DS80. DNP DS80 6. Photo imaging
Anche per DNP DS80: Manuale di avvio rapido (8 pagine), Manuale di reimballaggio (2 pagine)

Stampa la pagina

DS80DX Printers

TU80X Turning Unit

Replacing the Simplex Media

1. Pull out the media

compartment drawer by

lifting the blue handle

under the scrap box and

pulling gently.

2. Press the blue paper compartment release

lever on the side of the

paper compartment.

3. Remove the scrap box and

set it aside.

4. Remove the paper roll

from the printer. Remove

the spool ends from the paper roll by pulling

gently on the spools until they come off.

5. Set the spools into a new roll of paper.

ATTENTION:

Be sure there is no gap between the paper and

the spools. Failure to set correctly results in

paper jams.

6. Set the paper into the paper compartment.

Make sure the paper

roll is seated so that

the leading edge of the

paper roll is coming over

the top of the paper roll.

7. Remove the PULL

sticker from the paper.

DNP Imagingcomm America Corporation

DS-Series™ Printer Quick Reference

8. Advance the paper so that the paper is

coming over the top of the paper roll and

feeding into the printer at the front edge of the

DS80D Printer

paper compartment. The printer beeps when

the paper is in the correct position.

9. Replace the scrap bin and close the top of

the paper compartment.

10. If you are finished, close the media

compartment drawer.

ATTENTION:

The printer will not operate without the scrap bin

in place.

Installing a New Ribbon

1. Remove the old ribbon and

discard it. Set a new ribbon into

the ribbon cassette. Advance

the ribbon in the direction

shown, leaving no slack.

2. Place the cassette in the

printer with the supply side

the front.

3. Close the media

compartment drawer.

4. The printer will cycle through the status lights

as the media adjusts. When the media is

ready, four blank test images are printed.

ATTENTION (DS80DX ONLY):

Due to two different paper supplies (rolled

simplex and sheeted duplex paper) the printer

ribbon will run out before the paper. For ONLY

DS80DX printers, it is advised to change the

ribbon and paper as necessary, and not at the

same time.

Replacing the Duplex Sheet Paper

1. Remove the slide ramp from the printer.

2. Gently remove

3. Use the handle to

4. Throw away any left over

5. Verify that the silver

6. Locate the

7. Place the

8. Seat the paper guide against the paper -

9. Replace the paper tray in the turning unit,

10. Replace the scrap box by aligning notches on

11. Replace the slide ramp on the printer so that

the scrap box

by lifting the box

and away from the

turning unit.

pull the paper tray out

the turning unit.

paper.

paper lift and white

paper guide tab are

the correct positions and seated properly.

new sheet

paper pack.

paper pack in

the paper tray, making sure that the top and

bottom protective sheets are in place.

taking care no to bend the paper.

seating it completely in the turning unit.

the bottom of the box with the grooves in the

turning unit housing.

the paper feeds into the paper catchers.

Release: v01.2017

PN: 35-260-2-SA