DockCraft DS300 Istruzioni per il montaggio, l'installazione, la messa in opera e il funzionamento - Pagina 11

Sfoglia online o scarica il pdf Istruzioni per il montaggio, l'installazione, la messa in opera e il funzionamento per Attrezzatura per la nautica DockCraft DS300. DockCraft DS300 12.

Stampa la pagina

Now that the webbing length is set, Secure Loose end of webbing length as follows:

Position the 1st Webbing Keeper approximately

12 to 15 inches down from the cradle handle; on each

web strap.

Thread the loose end of webbing through Webbing Keeper

(each side of unit)

Note:

It is much easier to thread the webbing through the webbing keeper with the

Kayak out of the Kayak Rack.

Reposition the 2

webbing keeper and thread, similar to above, such that there

is 1 to 3 inches of webbing extended beyond the webbing keeper after threading.

Reload your Kayak, and rotate your kayak into its storage position.

You may place your Paddle in the loop between the handle and the 1

Dockside Operating Models

1 - Before unloading, check to Ensure that there

are no objects or people in the path of the

kayak when rotated toward the water.

2 - Standing on the Dock, grasp the tether cord

in one hand and then grasp the center of the

handle.

3 - Rotate the Latch Plates on both Pivot Laterals

90 degrees counterclockwise. Note: Securely

hold the handle as the Latch Plates are rotated

out of the way, the weight of the Kayak will

cause the Kayak Rack to want to rotate toward

the water.

4 - Firmly holding the tether cord, slowly lower the

kayak into the water, by releasing (hand over hand)

the length of the tether cord until your kayak is

in the water.

5 - Secure the end of the tether cord that is left in your

hand around one of the pivot laterals such that

you may float your kayak out of the rack.

Cam Buckle Loose End of Webbing

Cam Buckle Kayak End of Webbing

The Setup is now Complete.

Operating Instructions

1 – Use caution when lowering your kayak as

your kayak will be rotating to the water

toward you. Ensure you are physically fit to

manage the weight of lowering your kayak

and that there are not any obstacles in the

water that would cause you to trip.

2 - Stand in the water and center yourself

with the length of the kayak rack.

3 - Release the Latch Plates by rotating both

90 degrees clockwise.

4 - Grasp the center of the cradle handle with

both hands and slowly lower your kayak

into the water.

5 - Float your kayak completely out of the

rack and rotate the cradle back into its

storage position.

Page 11 of 12

webbing keeper.

Waterside Operating Models