Fleetwood 833311 Istruzioni per il montaggio

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Arredamento per interni Fleetwood 833311. Fleetwood 833311 2.

Carrel (Low & High) Assembly Instructions

STARTER/ADDER CARREL WITH HIGH ENDS SHOWN

Note: The assembly of this unit requires two people.

TOOLS REQUIRED:

Phillips Tip Screwdriver

Rubber Mallet

2. Locate the intermediate panel. Repeat Step 1 to attach

the end/intermediate panel to opposite end of the back

panel. Continue to repeat this step until all additional

intermediate panels, backs and opposite end panels

have been attached.

1. Locate the back panel and LH end panel. Attach back

panel to end panel by having one person hold the end

panel in an upright position and a second person slide

the back panel over the four shoulder screws located

near the back edge of the end panel. Once the back

panel has been slid downward enough to engage the

shoulder screws, use rubber mallet to properly seat the

modular clips.

*NOTE: Be sure the trough holes and worksurface

attachment holes are facing toward the inside of the

carrel.

3. Locate the worksurface. Attach the worksurface to the

end/intermediate panels. Note the relief cutouts on the

bottom of the worksurface near each of the modular

clips. Slide the worksurface between the

end/intermediate panels until the relief cutouts align

with the shoulder screws. Lower the worksurface and

slide toward the back panel to engage the shoulder

screws. Use the rubber mallet to properly seat the

modular clips onto the shoulder screws.

83.33-36-INST

Rev. A

Page 1 of