Acqiris U1084A Manuale di avvio - Pagina 12

Sfoglia online o scarica il pdf Manuale di avvio per PCI Card Acqiris U1084A. Acqiris U1084A 20. Acquisition card, 8-bit, up to 4 gs/s and 1.5 ghz bandwidth

Stampa la pagina

Step 4: Install the Module

The U1084A features a x4 PCIe bus interface, and should be installed in either a 4x, a x8 or x16

slot.

To fit the module to the PC / chassis please use the following procedure:

1. Ensure that the PC is switched off, and disconnect the power cord. Open the PC case.

2. Follow ESD precautions when handling and installing the U1084A.

3. When installing the U1084A ensure that it has optimum cooling, do not install it in a pos-

4. Loosen (but do not remove) the 4 screws holding the rear support bracket (shown in

5. Insert the module into the PCIe slot of the PC or chassis, ensuring that it is fully seated

6. Fit a screw to the top front panel and tighten it.

7. Fully extend the rear support bracket and ensure that it is inside the PCIe back plane

8. Tighten the 4 screws. (0.5 Nm torque)

9. Replace any covers and switch-on the PC. Check the module front panel indicators - a

ition where the integrated cooling fans may be obstructed.

violet in the diagram), and slide it towards the fans.

into the PCIe bus connector.

rail.

few seconds after the boot process, both the 'Status' and 'DPU' LEDs should be green.

Both the front panel screw and the rear support bracket must be used to

correctly support the unit. Failure to do this could result in damage to the

unit.

Acqiris U1084A Startup Guide