Etac Molift Partner 255 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Aiuto alla mobilità Etac Molift Partner 255. Etac Molift Partner 255 15.

Molift Partner 255 / www.etac.com

Charge the battery. The battery must not be in

the battery holder during assembly!

Place lifting column in chassis.

Make sure that the red arrow on the lower part of

the column corresponds with the edge of chassis.

Make sure screw on column is inside the hole

on chassis. This will prevent the column from

unintentionally being lifted out of chassis when

lock handle is pushed down.

Fix the column by pushing the lock handle on the

back all the way down.

1. Connect hand control to bottom of battery

holder.

2. Insert battery with terminals facing down.

3. Connect hand control wire to push handle

bracket so it does not fall to the floor when

dropped.

Assembly

1. Press the suspension bolt up and through the

lifting arm.

2. Make sure the bolt is correctly alligned befeore

pressing the plastic cup back on the arm.

3. Make sure suspension is properly fastened

Do not start using lifter before

completing control according to

checklist after assembly.

Use this checklist to verify that the lifter is properly

installed and can operate correctly and safely

before use.

Ensure that the lifting arm, lifting column and

suspension are properly fixed and that there

are no loose parts on the lifter.

Make sure battery is charged (no lights on the

battery lamps).

Check that the lifter has no apparent damage

or other faults.

Perform one lift with load (60-80 kg)