Fletcher-Terry Fletcher Saber 250-A Manuale d'uso - Pagina 3
Sfoglia online o scarica il pdf Manuale d'uso per Sega Fletcher-Terry Fletcher Saber 250-A. Fletcher-Terry Fletcher Saber 250-A 17. Accurate and efficient saw tooth hanger installation
Stampa la pagina
ÿþýü ú
Please read through this manual before operating the Saber™ 250-A. If
after reviewing these pages you still have questions about using the
machine, contact our Customer Service Department: (toll-free)
1.800.843.3826 in the U.S.; outside the U.S. call 860-677-7331;
ÿ
It is the employer's responsibility to enforce compliance with these safety warnings and
procedures by all who use the Saber 250-A. Keep this manual available so all employees
have access to it and the opportunity to review procedures periodically.
ÿ
The intended purpose of the Saber 250-A is to insert saw tooth hangers in picture frames
of various shapes, sizes, and materials. It must not be modified or used for any other
application or purpose.
ÿ
Use safety glasses. The operator of this machine, and others in the work area, must wear
safety glasses with rigid side shields. Wear ear protection. Ear protection is recommended
in any work environment where repetitive, mechanical machinery is in operation.
ÿ
Only connect the Saber 250-A to an air supply with a coupling that removes all pressure
when disconnected. Always disconnect the machine from the air supply before performing
maintenance, removing a jam or cleaning the Saber 250-A. Even if a hanger strip is not
visible on the guide, assume that there may be one or two hangers remaining in the
machine.
ÿ
Use clean, dry, regulated compressed air at a minimum pressure of 100 PSI at 2 CFM.
The system includes a filter and pressure regulator. Do not connect this machine to an air
supply with maximum potential pressure greater than 150 PSI.
ÿ
Never use oxygen, carbon dioxide, combustible gases or any type of bottled gas as a
source for this machine. Explosion and serious injury may result.
ÿ
Never use the machine if the air supply is compromised, the machine is missing parts, or
repair of the Saber 250-A is required. Do not use the machine if the safety warning labels
are missing or unreadable. Do not use the machine if the ram safety guard is missing or
broken. Contact a Fletcher-Terry Customer Service Representative for replacement labels
or parts.
ÿ
Only use the parts, supplies, and accessories that are recommended by Fletcher-Terry.
ÿ
Use care when loading the hanger strips onto the hanger guide, making sure that you do
not inadvertently activate the T-bar switch.
ÿ
Do not over-reach or use the Saber 250-A from an awkward or insecure position. Make
sure that the work area is well lit, free from clutter, and set up in a way that promotes
proper ergonomics.