Dodge Torque-Arm II TA8407HM Manuale di installazione e istruzioni

Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per Apparecchiature industriali Dodge Torque-Arm II TA8407HM. Dodge Torque-Arm II TA8407HM 4.

Stampa la pagina

Installation and Instruction Manual for Dodge

Tapered and Short Shaft Metric Bushing Assemblies

These instructions must be read thoroughly before installation or operation. This instruction manual was accurate at the time of

printing. Please see dodgeindustrial.com for updated instruction manuals.

WARNING: To ensure the drive is not unexpectedly

started, turn off and lock-out or tag power source before

proceeding. Failure to observe these precautions could

result in bodily injury.

WARNING: All products over 25 kg (55 lbs) are noted on the

shipping package. Proper lifting practices are required for

these products.

WARNING: Because of the possible danger to person(s) or

property from accidents which may result from the improper

use of products, it is important that correct procedures be

followed. Products must be used in accordance with the

engineering information specified in the catalog. Proper

installation,

maintenance

must be observed. The instructions in the instruction

manuals must be followed. Inspections should be made

as necessary to assure safe operation under prevailing

conditions. Proper guards and other suitable safety devices

or procedures as may be desirable or as may be specified in

safety codes should be provided, and are neither provided

by Dodge nor are the responsibility of Dodge. This unit and

its associated equipment must be installed, adjusted and

maintained by qualified personnel who are familiar with the

construction and operation of all equipment in the system

and the potential hazards involved. When risk to persons

or property may be involved, a holding device must be an

integral part of the driven equipment beyond the speed

reducer output shaft.

TA0107L-M

TA1107H-M

TA2115H-M

TA3203H-M

and

operation

procedures

TA4207H-M

TA5215H-M

TA6307H-M

TA7315H-M

BUSHING INSTALLATION

The Dodge Torque-Arm II Reducer is designed to fit both

standard and short length driven shafts. The Standard Taper

Bushings series is designed where shaft length is not a concern.

The Short Shaft Bushing series is to be used where the driven

shaft does not extend through the reducer.

Standard Taper Bushings

MINIMUM SHAFT LENGTH

Figure 1 - Minimum Recommended Dimensions

One bushing assembly is required to mount the reducer

on the driven shaft. An assembly consists of two tapered

bushings, bushing screws and washers, two bushing

backup plates and retaining rings, and necessary shaft

key or keys. The driven shaft must extend through the

full length of the reducer. If the driven shaft does not

extend through the reducer do not use the standard

tapered bushings; instead use the short shaft bushings as

described in the Short Shaft Bushings section that follows.

The minimum shaft length, as measured from the end of

the shaft to the outer edge of the bushing flange (see Figure

1), is given in Table 1 and shown in Figure 1.

Speed Reducer

TA8407H-M

TA9415H-M

TA10507H-M

TA12608H-M