Etac Molift Smart 150 Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Sistemi di sollevamento Etac Molift Smart 150. Etac Molift Smart 150 20.
Anche per Etac Molift Smart 150: Manuale d'uso (19 pagine)

Stampa la pagina

Operation

Battery charger

Molift Smart 150 is supplied with a battery with a

14,4 V cell unit that is placed in the battery hold-

er on the lift. A battery charger is also supplied to

be located easily accessible, either stand-alone or

mounted on the wall. Connect the charger mains

cable to the wall socket when charging the bat-

tery.

Disconnect the charger mains cable when

the charger is not used. Take care not to dam-

age the cable.

Place the battery in the holder according to the

arrow markings. After a few seconds the charger

LED will change from yellow to orange, indicating

that the battery is charging. When the LED gives a

constant green light the battery is fully charged.

The charger LED indicate the status of the battery

as described below:

LED

Yellow

Orange

Green/yellow

Green

Orange/green

Battery capacity

The battery indicator on the hand control will il-

luminate if the voltage of the battery falls below

a certain level, indicating the need for charging.

There will also be an audible signal There is still

enough capacity to perform 3-5 lift cycles (75 kg)

at this point. The battery indicator on the battery

BM09201 Molift SMART 150 English - Rev E 10/2012

Mode

No battery

Initialization (10 sec)

Fast charge

Top-off charge

Trickle charge

Error

holder illuminates only if the handcontrol unit is

disconnected and the battery needs charging.

If the battery is discharged during a lift, it is

always enough power to lower the user down

again.

New batteries will not achieve full capac-

ity before it has been fully charged and dis-

charged a couple of times.

The battery lifetime is about 500 charging cy-

cles.

Electronics

There is a counter implemented in the electronic

system of the lifter, registering the number of lifts.

This number can be read by using the Molift Servi-

cetool, and a service lamp indicates when the lift-

er needs service consisting of exchange of the lift-

ing motor. See the chapter "Maintenance".

The electronic system has a power save-function

which makes the system sleep after a while with

no activity. All lights will go out. Activate the sys-

tem by pushing one of the buttons on the hand

control.

If the lifter is run up and down constantly for a

longer period, the electronics may be overheated

and the lifter will stop. Wait until the lifter is cooled

down enough for further use.

Discarded lifters and batteries should be han-

dled as electronic waste and collected sepa-

rately according to local laws and regula-

tions.

Page 10 of 20